InMotion WS710726 Transfer Case Output Shaft Seal - Front or Rear

Transfer Case Output Shaft Seal

The InMotion WS710726 is a transfer case output shaft seal built for precise sealing performance and dependable contamination control. It uses PTFE sealing material and exact dimensional sizing to help maintain a tight barrier where the shaft passes through the housing.

Compatible With Ram 1500 transfer case applications and Audi Q7 transfer case applications listed below, this seal is a fitment-specific replacement for vehicles using the correct Borg-Warner transfer case configuration. The WS710726 is engineered to help reduce fluid leakage and keep moisture and debris away from internal components.

Key Features

• PTFE sealing material for low-friction sealing performance.
• Precision dimensions for a secure fit at the shaft and housing bore.
• Built to maintain a reliable barrier against contaminants.
• Transfer case sealing component for leak control and internal protection.
• InMotion WS710726 replacement part number for catalog matching.

Detailed Description

The WS710726 is a transfer case output shaft seal designed around the listed shaft and housing dimensions for accurate installation and sealing contact. Its PTFE construction supports consistent sealing at the interface between the shaft and housing, helping preserve transfer case fluid integrity and protect internal components from contamination. This part number, WS710726, is listed for Ram 1500 front transfer case applications with Borg-Warner 4444 or 4445 transfer cases, as well as Audi Q7 rear transfer case applications with a Borg-Warner 4430 transfer case. For buyers searching for a Ram 1500 transfer case output shaft seal or an Audi Q7 transfer case seal, WS710726 provides a direct catalog match for the specified applications.

What It Helps Solve

• Transfer case fluid seepage at the output shaft.
• Contamination from dust, moisture, and road debris.
• Seal wear that can lead to reduced sealing performance.
• Loss of internal protection around the shaft opening.

Installation Notes and Tips

Verify the transfer case model and application notes before installation, especially the Borg-Warner 4444, 4445, or 4430 references shown in fitment. Confirm shaft diameter, housing bore, and seal orientation match the original part before pressing the seal into place. Clean the sealing surface thoroughly to avoid premature wear.

Quality Assurance

InMotion manufactures this seal with precision and high-quality materials to support reliable sealing performance and long service life in transfer case applications.