InMotion WS710913 Automatic Transmission Output Shaft Seal - Right

Automatic Transmission Output Shaft Seal Overview

InMotion WS710913 is a precision seal built to maintain a tight barrier at the output shaft area and help keep contaminants out of the transmission sealing interface. It is a fitment-based replacement for select Acura and Honda applications, including right-side installations on the Acura RLX, Honda Accord, and Honda Odyssey.

Key Features

• Precision-fit seal dimensions for a secure sealing surface.
• High-quality construction for consistent sealing performance.
• Helps reduce fluid leakage at the output shaft interface.
• Helps block moisture and debris from entering the sealed area.
• Fits select Acura and Honda right-side applications.

Detailed Description

The InMotion WS710913 automatic transmission output shaft seal is engineered to provide a reliable seal where the shaft passes through the housing. Its measured inside diameter of 1.457 inches, outside diameter of 2.213 inches, thickness of 0.315 inches, and housing bore of 2.205 inches support accurate fitment in the specified applications. This part number, WS710913, is listed for right-side use on the Acura RLX, Honda Accord, Honda Odyssey, Acura MDX, Honda Crosstour, Acura TL, Acura ZDX, and Acura RL across the model years shown in the fitment data.

For buyers searching for an Acura RLX transmission seal, Honda Accord output shaft seal, or Honda Odyssey automatic transmission seal, WS710913 provides a direct replacement option for the listed vehicles and positions. It is intended to maintain sealing integrity and protect internal components from contamination that can contribute to premature wear.

What It Is Used For

• Stopping transmission fluid seepage at the output shaft area.
• Keeping dirt and moisture away from internal sealing surfaces.
• Replacing a worn, hardened, or damaged shaft seal.
• Addressing leaks that can lead to low fluid condition.
• Restoring sealing performance after service work.

Installation Notes and Tips

Confirm the vehicle year, make, model, and right-side application before installation. Inspect the shaft and housing surfaces for wear, scoring, or contamination before fitting the new seal. Clean the sealing area thoroughly and install the seal squarely to avoid distortion or premature leakage. Verify that the replacement dimensions match the original part number WS710913 application requirements.

Quality Assurance

InMotion manufactures this seal with precision and high-quality materials to support dependable sealing performance in the specified applications. The part is built to help maintain a secure barrier against contaminants and fluid loss.