Lesjofors 4295030 Coil Spring - Rear

Lesjofors Coil Spring 4295030 Overview

Lesjofors 4295030 is a replacement coil spring built to OE-quality standards for suspension service. It is manufactured from high-strength steel and finished with heat treatment, shot peening, zinc phosphate coating, epoxy powder coat paint, and pre-setting for consistent performance.

Seat included: No. This coil spring is a direct-fit suspension component for restoring ride height and spring support on the correct application.

Key Features

• Part number 4295030 coil spring for suspension repair
• Seat included: No
• High-strength steel construction
• Heat treated and shot peened for durability
• Zinc phosphate coated and epoxy powder coat painted for corrosion resistance
• Pre-set and tested before release
• Lesjofors replacement spring line used across OE-style applications

Application Details

Compatible with the application that cross-references to 171511105C. If you are sourcing a Lesjofors coil spring for a Volkswagen or Audi suspension repair, verify the original spring code and chassis details before ordering. Part number 4295030 is intended for direct replacement use where the original spring specification matches.

Lesjofors has a long spring-manufacturing history and supplies replacement coil springs engineered to meet or exceed OE quality expectations. The 4295030 spring follows that approach with controlled material selection, surface protection, and testing for consistent fit and function.

Common Problems This Part Can Address

• Sagging ride height from a fatigued coil spring
• Uneven stance caused by spring wear or breakage
• Noisy suspension operation from a damaged spring
• Reduced load support at one corner of the vehicle
• Restoration of factory spring rate when the original spring is no longer serviceable

Installation Notes

Replace coil springs in matched pairs when the opposite side shows similar wear. Confirm spring seat configuration, mounting position, and vehicle-specific spring code before installation. Use proper spring compression tools and follow factory service procedures during suspension disassembly and reassembly.

Quality Assurance

Lesjofors manufactures this spring using heat treatment, shot peening, zinc phosphate coating, epoxy powder coating, pre-setting, and testing to support consistent OE-style performance. Part number 4295030 is built for replacement use on the specified cross-referenced application.