Lesjofors 4444202 Coil Spring - Rear

Rear Coil Spring for Kia Rio

Lesjofors 4444202 is a rear coil spring for 2001-2005 Kia Rio models equipped with air conditioning. It is built as an OE-quality replacement for restoring rear suspension height, ride support, and load control on the Kia Rio.

Key Features

• Rear coil spring for 2001-2005 Kia Rio
• Compatible with vehicles equipped with air conditioning
• Seat included: No
• Manufactured from high-strength steel
• Heat treated, shot peened, zinc phosphate coated, and epoxy powder coated
• Pre-set and tested for consistent spring performance
• Lesjofors part number 4444202

Product Details

Lesjofors 4444202 is engineered as a direct replacement rear coil spring for the Kia Rio, with fitment covering 2001, 2002, 2003, 2004, and 2005 models. This spring is specified for rear suspension use on vehicles equipped with air conditioning, making it a focused solution for Kia Rio rear spring replacement work. Lesjofors has a long history in spring manufacturing, and this part reflects the brand’s OE-style construction approach with controlled material processing and corrosion-resistant finishing.

This part cross-references Dorman - HELP 81107 for the same application.

Common Repair Uses

• Restoring rear ride height on a Kia Rio
• Replacing a sagging or fatigued rear coil spring
• Addressing uneven rear stance on 2001-2005 Kia Rio models
• Correcting rear suspension noise caused by worn spring components
• Supporting proper rear load handling after spring wear

Installation Notes

Install on the rear suspension only. Verify that the vehicle is equipped with air conditioning before ordering or installation. Inspect spring seats, isolators, and adjacent suspension components during service, since this spring is listed with no seat included. Always replace springs in matched pairs when rear ride height or spring rate balance is a concern.

Quality Assurance

Lesjofors coil springs are manufactured to meet or exceed OE quality standards and are produced using high-strength steel, heat treatment, shot peening, zinc phosphate coating, epoxy powder coating, pre-setting, and testing for consistent performance.