Luk 07-013 Clutch Kit

LuK Clutch Kit for Ford Manual Transmissions

LuK 07-013 is a transmission clutch kit built for select Ford truck and van applications with an 11-inch clutch flywheel. It combines OE-style clutch components with application-specific engineering for Ford E-150 Econoline, E-250 Econoline, Bronco, F-100, F-150, F-250, and F-350 models from the 1980-1986 range.

For buyers searching for a Ford F-150 clutch kit, Ford Bronco clutch replacement, or a LuK 07-013 clutch kit for manual transmission service, this kit is organized around the key dimensions and release system details needed for a proper repair.

• Push type diaphragm pressure plate for the listed Ford manual transmission applications
• Clutch disc diameter: 11-1/16 inches
• Clutch diameter: 9-5/8 inches
• Clutch plate facing outer diameter: 10-15/16 inches
• Input shaft diameter: 1-1/16 inches
• Clutch disc spline quantity: 10
• Five clutch disc springs for driveline engagement characteristics
• Kit contents include cover assembly, clutch disc, release bearing, necessary pilots, and accessory pack

OE-Style Engineering and Fitment

LuK develops performance specifications for individual vehicle applications as an original-equipment supplier, and that application focus carries through to this clutch kit. The LuK 07-013 is built around the dimensions and release hardware required for select Ford E-Series vans, Bronco, and F-Series trucks with manual transmissions, including 1980-1986 Ford E-150 Econoline, 1983-1986 Ford E-250 Econoline, 1980-1983 Ford Bronco, 1980-1983 Ford F-100, 1980-1983 Ford F-150, 1980-1983 Ford F-250, and 1980-1983 Ford F-350 applications. This part cross-references AMS Automotive 07-013 for the same application.

Common Repair Uses

• Restores clutch engagement after disc wear or glazing
• Addresses slipping during acceleration under load
• Helps correct chatter, shudder, or uneven take-up
• Replaces worn release components during clutch service
• Supports repair of hard shifting caused by clutch wear or release issues

Installation Notes

Verify flywheel size, input shaft spline count, and pressure plate style before installation. Some 1983 Ford applications note an 11-inch clutch conversion requirement with six grade 8 3/8-inch-16 x 1-inch bolts and lock washers, and certain 1983 4.9L Ford F-series applications do not include the L93G pilot bearing. Confirm the vehicle’s manual transmission configuration and follow factory service procedures for alignment, torque, and release system setup. Search terms such as Ford Bronco clutch kit, Ford F-250 clutch replacement, and LuK 07-013 clutch kit are commonly used for these applications.

Quality Assurance

LuK is an OE supplier with extensive in-house manufacturing content, and its RepSet clutch components are built to match application-specific performance requirements for the listed Ford vehicles. The part number 07-013 is also referenced in aftermarket catalogs under 07-013K, 90250, 381113, 1107013, 52802006, 6283030770, K1009-02, and NU61009.