Mahle 3153 Engine Cylinder Head Gasket

Mahle 3153 Cylinder Head Gasket Overview

The Mahle 3153 engine cylinder head gasket is a composite sealing component built for precise combustion sealing and coolant/oil separation. It is a direct-fit style gasket for applications that call for a 1.65 mm thickness and a 100.01 mm cylinder bore diameter.

Mahle gaskets are used by OEMs and technicians worldwide for dependable sealing performance in engine service work. This Mahle 3153 gasket is a practical choice for cylinder head repair where accurate bore alignment and consistent gasket thickness matter.

Key Features

• Composite gasket material for engine sealing applications
• 1.65 mm thickness, also listed as 0.07 in
• 100.01 mm cylinder bore diameter, also listed as 3.94 in
• Gasket sealant not included
• Mahle OE-style sealing component for engine rebuild and repair work

Detailed Product Description

The Mahle 3153 engine cylinder head gasket is engineered for use in cylinder head sealing applications where the gasket must maintain compression, contain combustion pressure, and help separate oil and coolant passages. Its composite construction supports a balanced sealing surface for engine service procedures that require a measured gasket thickness and bore-specific fit. If you are sourcing a Mahle 3153 head gasket for engine repair, this part is built around the dimensional requirements listed above.

This part cross-references FEL-PRO 7799 CS for the same application. For buyers searching engine cylinder head gasket, composite head gasket, or Mahle 3153 replacement, this part supports those repair needs with the specified bore and thickness dimensions. It is also relevant for vehicle-specific searches such as Honda Civic engine gasket replacement and Honda Civic head gasket service when the application matches the engine requirements.

Common Repair Uses

• Head gasket replacement after combustion sealing failure
• Repair for coolant mixing with engine oil
• Correction of compression loss from a damaged cylinder head seal
• Service work after overheating-related gasket damage
• Engine rebuilds requiring a measured composite head gasket

Installation Notes

Verify cylinder bore diameter, gasket thickness, and engine specifications before installation. Clean the cylinder head and block mating surfaces thoroughly, and inspect both for warpage or damage before assembly. Follow the vehicle manufacturer’s torque sequence and tightening specifications during installation. Because gasket sealant is not included, use only the sealing method specified by the engine manufacturer.

Quality Assurance

Mahle supplies sealing products used by OEMs and professional technicians, and the 3153 follows the dimensional and material specifications listed for the application. No warranty information was provided in the product data.