Mahle MIS19311 Engine Intake Manifold Gasket Set

Mahle Intake Manifold Gasket Set MIS19311

Mahle MIS19311 is an OEM-standard intake manifold gasket set built for sealing service on select Ford trucks and vans. It includes molded rubber intake manifold gaskets plus the additional injector O-rings and injector crush washers needed for intake installation.

Key Features

• OEM-standard engine intake manifold gasket set
• Molded rubber intake manifold gasket material for a precise seal
• Includes upper and lower injector O-rings
• Includes injector crush washers
• Master set format for intake manifold service
• Package quantity: 60
• Plenum gasket not included

Detailed Description

Mahle MIS19311 is an engine intake manifold gasket set for Ford E-350 Super Duty, F-250 Super Duty, F-350 Super Duty, E-350 Club Wagon, and Excursion applications listed below. Built to OEM standard, this set is intended for intake manifold resealing where molded rubber sealing surfaces and injector sealing components are required. Mahle gaskets are used by OEMs and technicians worldwide for engine sealing applications, and this set follows that same service-focused approach. This part number, MIS19311, is a practical choice when replacing intake manifold seals on the correct Ford application.

Vehicle Fitment

• Fits 2004-2010 Ford E-350 Super Duty, N/A
• Fits 2003-2007 Ford F-250 Super Duty, N/A
• Fits 2003-2007 Ford F-350 Super Duty, N/A
• Fits 2004-2005 Ford E-350 Club Wagon, N/A
• Fits 2003-2005 Ford Excursion, N/A

Common Repair Uses

• Intake manifold gasket leaks
• Vacuum leaks at the intake sealing surface
• Fuel injector sealing service during intake removal
• Coolant or air leakage related to worn intake seals
• Reassembly after intake manifold service on Ford E-350 Super Duty, F-250 Super Duty, or F-350 Super Duty models

Installation Notes and Tips

Clean the mating surfaces thoroughly before installation and inspect the intake manifold and injector sealing areas for damage or warpage. Replace the upper and lower injector O-rings and injector crush washers during service, and verify that the plenum gasket is not required for your application since it is not included in this set. Confirm vehicle year, engine configuration, and intake layout against the listed fitment before installation. MIS19311 is a service gasket set, so proper torque sequence and fastener reuse guidelines should follow the vehicle service manual.

Quality Assurance

Mahle supplies OEM-standard sealing products trusted in engine repair and assembly. MIS19311 is built as a precision gasket set for intake manifold service on the listed Ford applications.