Mando 25A5388 ABS Wheel Speed Sensor - Rear Right

Mando OE ABS Wheel Speed Sensor

The Mando 25A5388 ABS wheel speed sensor is a New Original Equipment replacement for the rear right position on select Kia Rio models. It is built to restore accurate wheel speed signal input so the ABS system can operate as designed and help address ABS warning light concerns tied to sensor failure.

For drivers searching for a rear right ABS wheel speed sensor for 2012-2017 Kia Rio, this Mando OE part provides a direct-fit service solution backed by original-equipment engineering. Part number 25A5388 is also referenced for the same application as Kia 599301W000.

Key Features

• ABS wheel speed sensor for the rear right position
• New Original Equipment line from Mando
• Designed for 2012-2017 Kia Rio applications
• Supports accurate ABS wheel speed signal reporting
• OE-style replacement for brake system service

Detailed Description

Mando 25A5388 is an ABS wheel speed sensor for the rear right side of the Kia Rio. It is intended for 2012-2017 Kia Rio models and is a direct replacement for the original sensor used in the vehicle’s anti-lock brake system. When the sensor signal is lost or distorted, the ABS module can set a fault code and the brake system may not respond as expected during hard stops or low-traction conditions. This part helps restore proper wheel speed input so the ABS system can function with factory-level logic.

Mando’s New Original Equipment line focuses on OE replacement parts built for the same application and fitment standards as the original component. Part number 25A5388 is a practical choice for Kia Rio rear right ABS sensor replacement, and it cross-references Kia 599301W000 for the same application.

Common Issues This Part May Address

• ABS warning light illuminated on the dash
• ABS trouble code related to rear wheel speed signal loss
• Erratic or missing wheel speed data
• Extended stopping distance caused by ABS system faults
• Brake system performance concerns tied to a failed rear right sensor

Installation Notes and Tips

Verify the rear right position and confirm vehicle fitment before installation. Inspect the sensor connector, wiring, and tone ring area for damage or corrosion while servicing the brake system. Clear stored ABS codes after installation and road test the vehicle to confirm the warning light remains off.

Quality Assurance

Mando supplies this part through its New Original Equipment line, using OE-focused design and application matching for the Kia Rio brake system.