MAS Chassis CB43314 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm Assembly

MAS Chassis CB43314 is a direct replacement suspension control arm and ball joint assembly for select Volkswagen applications. It is built for the front right lower position on the Volkswagen Passat and Volkswagen Beetle, with a stamped steel arm, rubber bushings, and the ball joint already installed.

For drivers searching for a front right lower control arm for 2012-2022 Volkswagen Passat or 2012-2019 Volkswagen Beetle, this assembly provides an OE-style service part with the correct mounting style and dimensions for the listed applications.

Key Features

• Direct replacement control arm and ball joint assembly
• Fits the front right lower suspension position
• Stamped steel control arm with black finish
• Ball joint included and installed
• Rubber bushings included
• Bolt-in ball joint mounting type
• Mounting hardware included
• Standard grade construction

Detailed Description

MAS Chassis CB43314 is engineered as a replacement suspension control arm assembly for specific Volkswagen models. The stamped steel arm uses rubber bushings for the mounting points and a threaded-stud ball joint with bolt-in mounting, helping restore proper suspension geometry at the front right lower corner. This part number, CB43314, is listed for the 2012-2022 Volkswagen Passat and the 2012-2019 Volkswagen Beetle.

The manufacturer notes that this assembly goes through an evaluation process focused on ride quality, directional stability, and predictable handling characteristics. That makes it a practical choice when replacing a worn front lower control arm on a Volkswagen Passat or Volkswagen Beetle with symptoms tied to looseness, noise, or alignment concerns.

This part cross-references Beck/Arnley 102-7909 and Delphi TC3591 for the same application.

What It Helps Fix

• Clunking or knocking from the front suspension
• Excessive play in the lower control arm or ball joint
• Uneven tire wear related to suspension wear
• Steering pull or unstable directional control
• Alignment issues after control arm wear or failure

Installation Notes and Tips

Install CB43314 only on the listed front right lower applications. Verify mounting hole diameter, arm length, and ball joint style against the original part before installation. Because the ball joint is already installed, this assembly can reduce separate component matching during service. A professional alignment is recommended after replacement to confirm suspension angles and steering response.

Quality Assurance

MAS Chassis positions this assembly as a direct replacement part for the original equipment on the specified Volkswagen Passat and Volkswagen Beetle applications. The design is evaluated for consistent ride behavior, stability, and predictable suspension dynamics.