MAS Chassis CB69184 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

MAS Chassis CB69184 is a direct replacement suspension control arm and ball joint assembly for specific Nissan Altima applications. It is built for the front right lower position and is engineered to restore smooth ride quality, directional stability, and predictable steering response.

Fits 2007-2013 Nissan Altima, front right lower. This MAS Chassis CB69184 assembly is a practical OE-style solution for drivers replacing a worn lower control arm on the Nissan Altima.

Key Features

• Direct replacement for the original equipment control arm and ball joint assembly
• Fits 2007-2013 Nissan Altima, front right lower
• Aluminum control arm construction with a silver finish
• Ball joint included and installed for simplified service
• Rubber bushings included for proper suspension isolation
• Machined ball joint mounting with pinch-style stud design
• Two mounting holes with 14.2 mm mounting hole diameter
• Non-adjustable design for OE-style fit and function

Detailed Description

MAS Chassis CB69184 is designed as a replacement suspension control arm for the front right lower position on the 2007-2013 Nissan Altima. The aluminum casting/forged construction helps maintain the original suspension geometry, while the installed ball joint and included rubber bushings support controlled movement and road isolation. This part number, CB69184, is intended for applications where the original lower control arm has worn bushings, looseness at the ball joint, or reduced steering precision.

This part cross-references MOOG Chassis Products RK620196 for the same application. It also aligns with other OE-style replacement references used for the Nissan Altima platform, including CB69184 for service identification and ordering.

Common Repair Symptoms

• Clunking or knocking from the front suspension
• Uneven tire wear caused by worn suspension geometry
• Loose or wandering steering feel
• Vibration or instability during braking and cornering
• Cracked or deteriorated control arm bushings

Installation Notes

Verify vehicle position before installation: this assembly is for the front right lower location only. Compare the original control arm, ball joint stud style, and mounting dimensions before service. Mounting hardware is not included, so reuse or source the correct hardware as needed. After installation, perform a professional wheel alignment to confirm suspension geometry and steering angle.

Quality Assurance

MAS Chassis uses an industry-focused evaluation process for this suspension control arm and ball joint assembly to support consistent ride quality, directional stability, and predictable handling characteristics. CB69184 is built as a direct replacement part for the specified Nissan Altima applications.