Maval 9187M Rack and Pinion Assembly

Maval 9187M Remanufactured Rack and Pinion

The Maval 9187M remanufactured rack and pinion assembly is built for Volkswagen steering systems that use the TRW design. It is a direct-fit steering gear replacement for 1993-1998 Volkswagen Golf and Jetta, plus 1999 Golf and Jetta models built to 5/99 with the same TRW setup.

The Maval remanufactured rack and pinion line focuses on restoring steering response with application-specific fitment and OE-style port and mounting dimensions. Part number 9187M is built with inner tie rods included and uses a steel and aluminum casting for the rack housing.

• Remanufactured rack and pinion assembly for Volkswagen Golf and Volkswagen Jetta
• Fits 1993-1998 Volkswagen Golf, N/A, and 1993-1998 Volkswagen Jetta, N/A
• Fits 1999 Volkswagen Golf, N/A, to 5/99; all models with TRW design
• Fits 1999 Volkswagen Jetta, N/A, to 5/99; all models with TRW design
• Inner tie rods included
• 3.19 total turns lock to lock
• O-ring hose port type
• Pressure port thread size: M18 x 1.5
• Return port thread size: M16 x 1.5
• Rack length: 50.63 in. (1285.88 mm)
• Input shaft diameter: 0.69 in. (17.42 mm)
• Input shaft length: 1.13 in. (28.58 mm)
• Two mounting holes with 3.81 in. (96.85 mm) spacing

Detailed Fitment and Application

Part number 9187M is a steering rack replacement for Volkswagen Golf and Jetta models equipped with the TRW design. It is specified for 1993-1998 Volkswagen Golf and Jetta, and for 1999 Volkswagen Golf and Jetta built through 5/99. The rack length, mounting-hole spacing, shaft dimensions, and port thread sizes are listed to support accurate replacement selection for these Volkswagen steering applications.

This part cross-references Cardone Reman 26-1815 for the same application.

Common Steering Issues This Part Can Address

• Excessive steering play or delayed steering response
• Fluid leakage at the rack, pressure port, or return port
• Worn internal rack components causing uneven steering feel
• Noise or binding during steering input
• Failure of the original rack and pinion assembly on TRW-equipped Volkswagen Golf or Jetta models

Installation Notes and Tips

Verify the vehicle uses the TRW steering design before ordering. Confirm the pressure and return port thread sizes, input shaft dimensions, and mounting-hole spacing against the original unit before installation. After replacement, the steering system should be inspected for proper fluid routing, secure mounting, and correct alignment.

Quality Assurance

Maval remanufactured steering components are built as replacement assemblies for direct application matching. Part number 9187M is remanufactured to serve as an OE-style steering rack replacement for the listed Volkswagen Golf and Jetta fitments.