Mevotech CMS101663 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

Suspension Control Arm Assembly

Mevotech CMS101663 is a suspension control arm and ball joint assembly built for demanding passenger and commercial use. It combines an aluminum control arm with a pre-greased ball joint, rubber bushings, and a rubber dust boot for a service-ready replacement on select applications.

Engineered for vehicles that see frequent road use, this Mevotech Supreme Parts assembly is designed with application-specific upgrades to improve durability and simplify service. It is a direct-fit style suspension control arm assembly for drivers searching for a Mevotech CMS101663 replacement, including select Chrysler 200 and Dodge Dart applications.

• Pre-greased ball joint for reduced prep time
• Ball joint included with grooved stud type
• Aluminum control arm construction
• Rubber bushings included
• Rubber dust boot included with black boot color
• Silver control arm finish
• Non-adjustable design

Built for Service and Durability

Mevotech Supreme Parts are developed in-house with upgrades tailored to the application. CMS101663 is intended for high-usage passenger vehicles, SUVs, fleets, and working trucks where suspension wear can affect steering response, tire wear, and ride quality. If you are replacing a worn front suspension control arm and ball joint assembly on a Chrysler 200 or Dodge Dart, this part number provides a focused OE-style solution.

This part cross-references Beck/Arnley 102-8324 for the same application.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play from a worn ball joint
• Uneven tire wear caused by suspension looseness
• Steering wander or reduced front-end stability
• Cracked or deteriorated control arm bushings

Installation Notes

CMS101663 arrives with the ball joint pre-greased and the bushings and dust boot included, which can reduce prep during installation. Verify vehicle application, position, and suspension geometry before installation, and inspect related components such as tie rods, struts, and alignment settings after replacement. Because this is a non-adjustable aluminum control arm assembly, proper fitment confirmation is important before service.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades for durability and performance. The Labor Saver design approach is used to make installation faster and easier through thoughtful tooling and hardware-focused engineering. Part number CMS101663 is built to meet the needs of demanding daily-use vehicles and fleet service environments.