Mevotech CMS501310 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm Assembly

Mevotech CMS501310 is a suspension control arm and ball joint assembly for the front left lower position on select Chevrolet Spark models. It combines a steel control arm, pre-greased ball joint, and rubber bushings in one OE-style replacement assembly for direct service on the front suspension.

Key Features

• Fits 2016-2022 Chevrolet Spark, front left lower
• Pre-greased assembly for ready-to-install service
• Steel control arm with black corrosion-resistant finish
• Ball joint included with grooved stud and bolt-in mounting type
• Rubber bushings included for suspension isolation
• Non-adjustable design for OE-style replacement fit
• Mevotech CMS501310 cross-references 95368367 for the same application

Detailed Description

Built for the front left lower suspension position, Mevotech CMS501310 is a complete control arm and ball joint assembly for Chevrolet Spark models from 2016 through 2022. The steel arm measures 13.0 inches in maximum length and width, and the black finish adds corrosion resistance for long-term service in exposed undercar conditions. With the ball joint and rubber bushings already included, this assembly supports a straightforward replacement of worn front suspension components. Mevotech CMS501310 is a direct-fit solution for Chevrolet Spark front suspension repair where the original arm, bushings, or ball joint have reached the end of service life.

Common Repair Uses

• Front-end clunking or looseness from worn bushings
• Uneven tire wear related to suspension wear
• Steering wander caused by a worn ball joint assembly
• Noise over bumps from a fatigued lower control arm
• Corrosion-related replacement of the front left lower arm

Installation Notes and Tips

Verify the front left lower position before installation and confirm vehicle year and trim against the fitment data for your Chevrolet Spark. Because the ball joint uses a bolt-in mounting type and a grooved stud, proper alignment of the joint and fasteners is important during service. A wheel alignment should be performed after suspension replacement to restore correct geometry.

Quality Assurance

Mevotech supplies suspension replacement parts for OE-style service applications, and CMS501310 is built with a steel arm, rubber bushings, and a pre-greased ball joint for consistent replacement quality.