Mevotech DX410 CV Joint Boot - Front Inner or Front Right Inner

Mevotech DX410 CV Joint Boot for Front Inner Axles

Mevotech DX410 is a front CV joint boot built for front inner and front right inner applications on select Honda, Acura, Dodge, Ford, and Mercury vehicles. Made from neoprene and supplied with grease and two adjustable clamps, it provides the core service parts needed for a CV boot replacement on the axle shaft.

Key Features

• Neoprene construction for flexible CV joint protection
• Conical boot design for front inner axle service
• Includes grease and 2 clamps
• Adjustable clamps for a secure fit
• Front position application
• Cross-reference: 86-2494

Detailed Product Overview

The Mevotech DX410 CV joint boot is a direct-fit driveline service part for maintaining the protective seal around the CV joint. It is listed for 2015-2018 Honda CR-V, front inner; 2015-2017 Acura TLX, front inner; 2015-2017 Honda Accord, front inner; 2013-2016 Dodge Dart, front inner and front right inner; 2010-2012 Ford Fusion, front inner; 2008-2011 Ford Focus, front inner; and 2010-2011 Mercury Milan, front inner. If you are replacing a torn boot on a Honda Accord front inner axle or servicing a Ford Fusion front inner CV joint, DX410 provides the boot, grease, and clamp set needed for the repair.

Common Repair Uses

• Replacing a cracked or split CV boot
• Restoring grease retention around the CV joint
• Addressing clicking or contamination caused by boot failure
• Servicing front inner axle boots on listed Honda, Acura, Dodge, Ford, and Mercury models
• Repairing a damaged boot before the CV joint wears further

Installation Notes

Confirm axle position before ordering, since this part is listed for front inner and front right inner applications only. Inspect the CV joint for wear or contamination before installation, clean the joint thoroughly, and pack the boot with the supplied grease during assembly. Verify clamp placement and diameter adjustment before securing the boot to the axle and joint housing. Part number DX410 should be matched to the vehicle application and position shown in the fitment data.

Quality Assurance

Mevotech supplies driveline hardware and service parts for repair-focused applications. DX410 is built as a neoprene CV boot assembly with included grease and adjustable clamps for the specified fitments. This part cross-references 86-2494 for the same application.