Mevotech DX593 CV Joint Boot - Front Inner or Rear Inner

Mevotech DX593 CV Joint Boot for Rear and Front Inner Applications

The Mevotech DX593 is a neoprene CV joint boot built for select Jeep and Land Rover driveline applications. It is a cylindrical boot for rear inner use, with front inner coverage on specific Jeep Grand Cherokee models equipped with an electronic locking differential.

Key Features

• Neoprene construction for flexible CV joint protection
• Cylindrical boot profile for inner CV joint service
• Rear position coverage, with select front inner fitment
• Large-end clamp minimum diameter: 2.826 in.
• Grease not included
• Mevotech DX593 part number for direct reference

Detailed Product Overview

Mevotech DX593 is a replacement CV joint boot for driveline service on select Jeep Grand Cherokee, Land Rover LR4, Land Rover Range Rover Sport, Land Rover Range Rover, and Land Rover LR3 applications. The neoprene material provides a serviceable sealing surface for inner CV joints, helping retain grease and keep contaminants out of the joint area. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Compatible With: Fits 2015-2017 Jeep Grand Cherokee, front inner with Electronic Locking Differential; Fits 2011-2014 Jeep Grand Cherokee, front inner; Fits 2010-2015 Land Rover LR4, rear inner; Fits 2006-2013 Land Rover Range Rover Sport, rear inner; Fits 2007-2012 Land Rover Range Rover, rear inner; Fits 2006-2009 Land Rover LR3, rear inner. The DX593 part number is used across these driveline service applications for accurate ordering and identification.

Common Problems This Boot Can Address

• Cracked or torn CV boot material
• Grease leakage from the inner CV joint area
• Road debris and moisture intrusion into the joint
• Boot deterioration during driveline maintenance
• Noise or vibration caused by a compromised boot and contaminated joint

Installation Notes and Tips

Inspect the CV joint, axle shaft, and clamps before installation. Clean all mating surfaces thoroughly and verify the large-end clamp diameter matches the application at 2.826 in. Because grease is not included, use the correct CV joint grease specified for the vehicle and joint assembly. Confirm position and fitment by year, make, model, and inner joint location before service.

Quality Assurance

Mevotech manufactures driveline service parts for repair applications that require accurate fitment and material selection. Verify the DX593 against the vehicle’s inner CV joint configuration before installation.