Mevotech G513316 Wheel Bearing and Hub Assembly - Front or Rear

OE-Style Hub Bearing Assembly

Mevotech G513316 is a wheel bearing and hub assembly built to match original manufacturer fit, form, and function. It is a direct replacement for front and rear applications on select Buick, Chevrolet, and Cadillac models, including the Chevrolet Malibu and Buick Encore GX.

Mevotech G513316 is pre-greased and uses a Gen 3 bearing design to restore OE-level wheel support, handling, and ride quality for routine driving.

Key Features

• Exact-match replacement for original equipment fit and function
• Gen 3 bearing generation for modern hub service applications
• Pre-greased for ready-to-install service
• 5 wheel studs for hub-to-wheel attachment
• 3 flange bolt holes for mounting
• Inside diameter: 70.1 mm
• Outside diameter: 115.0 mm
• Anti-lock brake sensor not included

Detailed Description

This Mevotech Original Grade hub bearing assembly is engineered as an OE-style replacement for everyday commuters and routine drivers who need consistent wheel support and stable road feel. Part number G513316 is used across a wide range of applications, including Fits 2016-2025 Chevrolet Malibu, Front and Fits 2020-2026 Buick Encore GX, Front. It also serves select Cadillac CT4 rear applications and other front-position vehicles listed in the fitment data.

This part cross-references Timken HA590404 for the same application. If you are replacing a worn hub on a Chevrolet Trax, Buick Envista, or Chevrolet Trailblazer, G513316 provides a direct-fit service solution that follows the original design intent.

Common Problems This Part Can Address

• Wheel bearing noise such as humming, growling, or rumbling
• Excessive wheel play or looseness at the hub
• Uneven wheel rotation caused by bearing wear
• Vibration or roughness felt through the chassis
• Hub wear that affects steering response and ride quality

Installation Notes and Tips

Verify the vehicle position before ordering, since this hub assembly is used in both front and rear applications depending on the model. Confirm the flange bolt hole count, wheel stud count, and sensor requirements against the original part before installation. Because the anti-lock brake sensor is not included, reuse or source the correct sensor arrangement for the vehicle if required.

For best results, inspect the mating surfaces, axle components, and fasteners for wear or corrosion during service. This part number is commonly searched as Mevotech G513316 and G513316 for OE replacement hub bearing service.

Quality Assurance

Mevotech Original Grade parts are built to match the original manufacturer’s fit, form, and function, with OE performance, handling, and ride characteristics in mind for regular driving use.