Mevotech GES2079S Steering Tie Rod End Adjusting Sleeve - Front, Front Left or Front Right

Mevotech GES2079S Steering Adjusting Sleeve

The Mevotech GES2079S is a steel steering tie rod end adjusting sleeve built for front steering service on a wide range of Ford, Jeep, and Mazda applications. It uses a black painted finish, medium thread, and a two-female-end configuration with clockwise and counterclockwise thread directions for steering linkage adjustment.

Compatible With front steering setups on Ford E-Series vans, Ford F-Series trucks, Jeep Cherokee and Wrangler models, and select Mazda and Ranger applications, this adjusting sleeve supports precise tie rod length adjustment during steering repair. The GES2079S part number is also commonly searched for replacement steering hardware needs.

Key Features

• Steel construction for steering linkage durability
• Adjustable design for tie rod length setup
• Two female ends with M22 x 1.5 thread size
• Clockwise and counterclockwise thread direction for alignment adjustment
• Black painted finish
• Mounting hardware and clamps included
• Standard grade type with bracket mounting method

Detailed Description

This steering tie rod end adjusting sleeve is used to connect and fine-tune steering linkage geometry where front toe adjustment is required. The Mevotech GES2079S is built from steel and measures 4.96 inches in length with a 1.3-inch diameter, giving it the dimensions needed for common front steering service on Ford E-150, E-250, E-350 Super Duty, Bronco, Ranger, F-150, F-250, and related Jeep and Mazda platforms. This part cross-references MOOG Chassis Products ES2079S and Delphi TA2269 for the same application.

Use the GES2079S when servicing front left or front right steering positions listed in the fitment data, including tie rod to steering arm and pitman arm to steering arm locations. The Mevotech GES2079S is a direct-fit steering hardware solution for technicians replacing worn or corroded adjusting sleeves on older and newer Ford truck and van steering systems.

What It Helps Address

• Loose or worn steering linkage adjustment points
• Corrosion-damaged adjusting sleeves
• Difficulty setting front toe alignment
• Steering play caused by damaged tie rod hardware
• Replacement needs during front-end steering service

Installation Notes and Tips

Verify thread direction, thread size, and position before installation. This sleeve uses medium threads with both clockwise and counterclockwise directions, so matching the correct side is important for proper steering adjustment. Confirm the vehicle application, including front left or front right placement and any notes such as tie rod to LH steering arm or pitman arm to RH steering arm, before final alignment.

After installation, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Check adjacent steering components for wear before completing the repair.

Quality Assurance

Mevotech manufactures this adjusting sleeve as a standard-grade steering hardware component with steel construction, painted finish, and included clamps and mounting hardware. The GES2079S is built to match the listed OE-style applications for Ford, Jeep, and Mazda steering service.