Mevotech GK5248 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Mevotech GK5248 Stabilizer Bar Bushing Kit

Restore front sway bar support with the Mevotech GK5248 suspension stabilizer bar bushing kit. Built from natural rubber with a black finish, this bushing set is made for front-to-frame applications where the stabilizer bar needs a precise, quiet fit. It is a direct-match option for a wide range of Chevrolet, GMC, Pontiac, Buick, Cadillac, and Oldsmobile vehicles, including Chevrolet Camaro, GMC Yukon, and Pontiac Firebird applications.

Key Features

• Natural rubber construction for a compliant, OE-style bushing feel
• Black finish for a clean, factory-style appearance
• Inside diameter: 1.181 in. for 30 mm / 1-3/16 in. bar applications
• Designed for front-to-frame stabilizer bar mounting
• Dimensions: 3.85 in. width, 2.22 in. outside diameter, 1.625 in. height, 1.6 in. length
• Cross-reference: MOOG Chassis Products K5248

Detailed Description

The Mevotech GK5248 is a suspension stabilizer bar bushing kit engineered for front-to-frame use on vehicles with a 30 mm stabilizer bar diameter or 1-3/16 in. bar diameter. Its natural rubber material helps maintain the stabilizer bar’s position at the frame, supporting consistent suspension response and reducing unwanted movement at the mounting point. This part number is commonly searched for fitment on Chevrolet Camaro, GMC Yukon, and Pontiac Firebird models, along with many full-size GM cars and trucks.

Mevotech GK5248 is a practical replacement for worn or compressed sway bar bushings on vehicles such as Chevrolet K1500, GMC K1500, and Cadillac Fleetwood applications. If you are servicing a front stabilizer bar bushing on a GM platform with the correct bar diameter and no bracket requirement, this part number is a direct fitment reference to verify against your vehicle.

What It Helps Address

• Clunking or rattling from the front stabilizer bar area
• Excessive sway bar movement at the frame mount
• Worn, cracked, or flattened rubber bushings
• Loose-feeling front suspension response over bumps
• Noise caused by deteriorated sway bar support points

Installation Notes and Tips

• Confirm the vehicle uses a front-to-frame stabilizer bar mount.
• Verify the stabilizer bar diameter is 30 mm or 1-3/16 in.
• Check that your application does not require a bracket-style bushing.
• Inspect the stabilizer bar and mounting surfaces for wear before installation.
• Match the part number and fitment notes to your exact year, make, and model before ordering.

Quality Assurance

Mevotech GK5248 is built as a replacement suspension bushing kit using natural rubber for application-specific fitment. It cross-references MOOG Chassis Products K5248 and other listed aftermarket numbers for the same application, helping simplify part matching during suspension service.