Mevotech GK8731 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Mevotech GK8731 Front Stabilizer Bar Bushings

Restore proper sway bar support with the Mevotech GK8731 suspension stabilizer bar bushing kit. Built from natural rubber with a black finish, this front-to-frame bushing set is made for vehicles using a 25.4 mm, or 1 in, front stabilizer bar diameter.

Fits 1991-2002 Lincoln Town Car, front to frame; Fits 1992-2002 Ford Crown Victoria, front to frame; Fits 1992-2002 Mercury Grand Marquis, front to frame.

• Natural rubber construction for stable bar isolation and road noise control
• Front-to-frame design for the stabilizer bar mounting point
• Inside diameter: 1.0 in for 25.4 mm sway bars
• Black finish for a clean OE-style appearance
• Designed for vehicles with the specified front stabilizer bar diameter

Detailed Product Overview

The Mevotech GK8731 is a suspension stabilizer bar bushing kit engineered for front frame mounting applications on the Ford Crown Victoria, Lincoln Town Car, and Mercury Grand Marquis. Its natural rubber material helps maintain a secure fit around the sway bar while reducing unwanted movement at the chassis mounting point. With an inside diameter of 1.0 inch, this part is matched to vehicles equipped with a 25.4 mm front stabilizer bar.

This part cross-references MOOG Chassis Products K200165 and QuickSteer K8731 for the same application. The Mevotech GK8731 is a direct-fit service part for front-to-frame stabilizer bar service on the listed full-size Ford and Lincoln platforms.

Common Repair Uses

• Clunking or rattling from the front suspension over bumps
• Excessive sway bar movement at the frame mount
• Worn, cracked, or flattened stabilizer bar bushings
• Loose-feeling front suspension response during cornering
• Noise caused by deteriorated rubber at the sway bar mounting point

Installation Notes and Tips

Verify the front stabilizer bar diameter before installation; this part is specified for 25.4 mm or 1 inch bars. Confirm the vehicle application and front-to-frame mounting location on the Crown Victoria, Town Car, or Grand Marquis before service. Inspect the stabilizer bar and mounting surfaces for wear or corrosion so the new bushings seat properly.

Quality Assurance

Mevotech GK8731 is built as a suspension service component for the listed applications and uses natural rubber construction for consistent fit and function in front stabilizer bar mounting service.