Mevotech GK90011 Suspension Stabilizer Bar Bushing Kit - Front To Frame

Front Stabilizer Bar Bushing Kit for Honda and Isuzu

Mevotech GK90011 is a rubber suspension stabilizer bar bushing kit built for front-to-frame applications on select Honda and Isuzu vehicles. It supports the sway bar where it mounts to the frame, helping maintain consistent suspension control and steering response on rough roads.

• Rubber construction for frame-mounted stabilizer bar applications
• Inside diameter: 1.06 in.
• Outside diameter: 1.39 in.
• Width: 3.35 in.
• Height: 2.45 in.
• Length: 1.61 in.
• Design type: to frame
• Fits front to frame positions on select Passport, Rodeo, and Amigo models

Detailed Product Overview

Mevotech GK90011 is a suspension stabilizer bar bushing kit engineered for front-to-frame mounting points. The rubber material helps isolate the stabilizer bar from the frame while maintaining the correct fit for the bar diameter and bracket location. This part is a direct-fit style replacement for applications that use a 1.06-inch inside diameter and the listed bushing dimensions. It cross-references MOOG Chassis Products K90011 for the same application.

Compatible With 1994-1997 Honda Passport, Front To Frame; 1991-1997 Isuzu Rodeo, Front To Frame; and 1989-1994 Isuzu Amigo, Front To Frame. Search terms such as Honda Passport front sway bar bushing, Isuzu Rodeo stabilizer bar frame bushing, and Isuzu Amigo front stabilizer bushing all point to this application. The part number GK90011 is also useful when matching OE-style suspension service parts for these vehicles.

Common Issues This Part Can Address

• Clunking or knocking from the front suspension over bumps
• Excessive sway bar movement at the frame mount
• Loose or worn stabilizer bar bushing fitment
• Reduced steering stability caused by deteriorated rubber bushings
• Noise from dry, cracked, or compressed sway bar bushings

Installation Notes and Tips

Verify the stabilizer bar diameter and frame-mount style before installation. Compare the old bushing dimensions to the listed measurements for GK90011 to confirm fitment on your Honda Passport, Isuzu Rodeo, or Isuzu Amigo. Clean the mounting surface and inspect the stabilizer bar and brackets for wear before installing the new rubber bushing.

Quality Assurance

Mevotech suspension components are built for service replacement applications with attention to fit and dimensional accuracy. GK90011 is specified for confirmed front-to-frame fitment on the listed vehicles and is a direct cross-reference to MOOG Chassis Products K90011.