Mevotech GS10442 Suspension Control Arm Bushing - Front Lower Inner Forward

Mevotech GS10442 Suspension Control Arm Bushing

The Mevotech GS10442 is a press-in suspension control arm bushing made from natural rubber for front lower inner forward locations. It is built for BMW applications that need a direct-fit bushing replacement to restore suspension articulation and control arm support.

Key Features

• Natural rubber construction for OE-style compliance and vibration isolation
• Press-in mounting type for front lower inner forward control arm service
• Silver finish with a 0.47 inside diameter and 2.77 outside diameter
• Measures 2.99 in length with 0.1 wall thickness
• Fits BMW Z4, X1, 128i, 135i, 328i, 335i, 335is, 335d, 323i, 325i, and 330i applications
• Mevotech GS10442 is listed with direct interchange references for common aftermarket cross-matches

Detailed Description

Mevotech GS10442 is a suspension control arm bushing for front lower inner forward mounting positions on select BMW vehicles. The natural rubber material is selected for controlled flex and road isolation, while the press-in design supports a secure fit in the control arm assembly. This part number is commonly searched for BMW Z4 and BMW 3 Series front suspension service, including 328i and 335i applications.

This part cross-references MOOG Chassis Products K200089 and Beck/Arnley 101-7516 for the same application. Mevotech GS10442 also aligns with Mevotech Original Grade GS10442 and Mevotech Supreme MS10442 catalog references.

What It Helps Address

• Front suspension looseness from worn control arm bushings
• Clunking or knocking from deteriorated rubber mounts
• Excessive vibration transferred into the chassis
• Uneven steering response caused by bushing wear
• Control arm movement that affects alignment stability

Installation Notes and Tips

Install GS10442 in the front lower inner forward position only where specified by the vehicle catalog. Because this is a press-in bushing, proper removal and installation tools are recommended to avoid damaging the control arm or the new bushing. Verify the control arm bore, bushing dimensions, and vehicle application before assembly. For BMW Z4, X1, and 3 Series service, confirm the exact suspension position before pressing the part into place.

Quality Assurance

Mevotech GS10442 is built as an OE-style suspension service part using natural rubber and application-specific dimensions for the listed BMW fitments. The part number is supported by multiple aftermarket interchange references, which helps confirm catalog alignment for front lower inner forward control arm service.