Mevotech GS25041 Steering Drag Link - At Spindle

Mevotech GS25041 Steering Drag Link

Mevotech GS25041 is a steering drag link for Jeep Wrangler JK and Jeep Wrangler applications at the spindle. With a 33.75-inch length, 3.35-inch width, and painted finish, this component is built for direct steering linkage replacement where precise fitment matters. It is a practical choice for Jeep Wrangler JK steering repair and Jeep Wrangler drag link service.

Key Features

• Steering drag link for the steering, gear and related components category
• 33.75-inch length for application-specific steering linkage fitment
• 3.35-inch width
• Painted finish for corrosion-resistant surface protection
• Fits at spindle mounting position
• Mevotech GS25041 part number for easy identification

Detailed Description

Mevotech GS25041 is a steering drag link engineered for Jeep Wrangler JK and Jeep Wrangler models that mount at the spindle. This part is used in the steering linkage to transfer motion accurately between steering components, helping restore proper steering response when the original drag link is worn or damaged. The 33.75-inch length and 3.35-inch width provide the dimensional reference needed for correct replacement selection, while the painted finish adds a protective outer layer. This Mevotech GS25041 drag link also cross-references Mopar 52060048AD for the same application.

Vehicle Fitment

• Fits 2018 Jeep Wrangler JK, At Spindle
• Fits 2007-2017 Jeep Wrangler, At Spindle

Common Repair Uses

• Steering looseness caused by a worn drag link
• Clunking or play in the steering linkage
• Uneven steering response at the spindle connection
• Replacement after corrosion or physical damage
• Restoration of steering geometry on Jeep Wrangler JK and Jeep Wrangler models

Installation Notes and Tips

Verify the spindle-side mounting location before installation and compare the original part length and width to Mevotech GS25041. After replacement, inspect related steering components for wear and perform a proper alignment check to confirm steering geometry is set correctly.

Quality Assurance

Mevotech supplies steering and chassis components for OE-style replacement applications, and GS25041 is identified by the manufacturer part number for accurate ordering and fitment verification.