Mevotech GS251151 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

Mevotech GS251151 is a front right lower suspension control arm and ball joint assembly built for Ram 1500 and Ram 1500 Classic applications. It is an exact-match replacement for the original part’s fit, form, and function, making it a direct choice for restoring OE ride quality and steering response.

Fits 2013-2018 Ram 1500, front right lower. Fits 2019-2024 Ram 1500 Classic, front right lower.

Key Features

• Original Grade OE replacement for factory-style fit and geometry
• Aluminum control arm construction with silver finish
• Pre-greased ball joint for service-ready installation
• Press-in ball joint design with threaded stud
• Rubber bushings and rubber dust boot for suspension isolation
• Castle nut, cotter pin, and mounting hardware included where required
• Ball joint included and dust boot included
• Non-adjustable design for direct replacement use

Detailed Description

Mevotech GS251151 is engineered as a premium OE replacement for the front right lower position on Ram 1500 and Ram 1500 Classic trucks. The aluminum arm helps maintain factory suspension dimensions, while the included rubber bushings support controlled movement and road isolation. The pre-greased, press-in ball joint with threaded stud is built for direct service replacement, and the included hardware helps streamline the repair process. This part cross-references MOOG Chassis Products RK623100 and Dorman OE Solutions 527-058 for the same application.

For drivers searching for a front right lower control arm for 2013-2018 Ram 1500 or 2019-2024 Ram 1500 Classic, GS251151 provides an OE-style solution that restores suspension alignment points and steering feel. The Mevotech GS251151 part number is also commonly referenced in suspension replacement searches for these Ram truck platforms.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play at the ball joint or control arm pivot points
• Uneven tire wear caused by worn suspension geometry
• Loose or imprecise steering feel
• Ride quality changes from deteriorated bushings

Installation Notes and Tips

Verify the front right lower position before installation and compare the original arm, ball joint style, and mounting points to the replacement part. Because this assembly uses a press-in ball joint design, proper suspension service tools and alignment procedures are recommended after installation. Always inspect related components such as tie rods, wheel bearings, and other front suspension wear items while the vehicle is apart.

Quality Assurance

Mevotech Original Grade parts are built to match the original manufacturer’s fit, form, and function for routine driving and commuter use. GS251151 is intended to restore OE performance, handling, and ride characteristics on Ram 1500 and Ram 1500 Classic applications.