Mevotech GS25431 Suspension Control Arm Bushing - Rear To Axle (Lower Rear)

Suspension Control Arm Bushing for Rear Axle Location

Mevotech GS25431 is a suspension control arm bushing built for the rear to axle, lower rear position on select Dodge and Jeep applications. It uses natural rubber construction to provide a direct-fit replacement for worn suspension pivot points in the rear suspension.

Compatible with 2007-2009 Dodge Nitro, 2006-2009 Jeep Commander, 2005-2009 Jeep Grand Cherokee, and 2008-2009 Jeep Liberty in the rear to axle (lower rear) position, this bushing supports precise suspension movement where the control arm connects to the axle.

Key Features

• Natural rubber construction for suspension isolation and pivot support
• Designed for the rear to axle (lower rear) control arm location
• Outside diameter: 2.36 in.
• Inside diameter: 0.56 in.
• Length: 5.0 in.
• Wall thickness: 0.9 in.
• Silver finish
• Direct replacement for Mevotech GS25431 applications

Detailed Description

Mevotech GS25431 is a suspension control arm bushing engineered for rear suspension service on Dodge Nitro, Jeep Commander, Jeep Grand Cherokee, and Jeep Liberty models listed above. The natural rubber material helps restore the control arm’s mounting interface at the axle, supporting stable rear suspension articulation and consistent alignment behavior. This part number also cross-references MOOG Chassis Products K200178 for the same application.

For buyers searching for a rear lower control arm bushing for 2005-2009 Jeep Grand Cherokee, 2006-2009 Jeep Commander rear to axle lower rear bushing, or a 2007-2009 Dodge Nitro rear suspension bushing, GS25431 is the matching service part to verify against the vehicle’s original configuration.

Common Repair Uses

• Clunking or knocking from the rear suspension
• Excessive play at the control arm-to-axle mounting point
• Cracked, dry-rotted, or separated rubber bushings
• Rear suspension noise over bumps or uneven roads
• Alignment instability caused by worn rear control arm bushings

Installation Notes and Tips

Confirm the rear to axle (lower rear) position before ordering, since this bushing is application-specific. Inspect the control arm, mounting surfaces, and surrounding suspension components for wear or damage during service. Press-fit suspension bushings typically require proper removal and installation tools to avoid damaging the arm or the new bushing.

Quality Assurance

Mevotech GS25431 is an OE-style suspension service part for the listed Dodge and Jeep applications. It is cross-referenced to Mevotech Original Grade GS25431 and Mevotech Supreme MS25431 for the same fitment family.