Mevotech GS25433 Suspension Control Arm Bushing - Rear Upper To Axle

Suspension Control Arm Bushing for Rear Upper Axle Mount

Mevotech GS25433 is a suspension control arm bushing built with natural rubber for the rear upper to axle location. It is a direct-fit replacement for select Jeep and Dodge applications, including Jeep Commander, Jeep Grand Cherokee, Jeep Liberty, and Dodge Nitro.

Use Mevotech GS25433 when you need a replacement bushing for rear upper to axle suspension service on the Commander, Grand Cherokee, Liberty, or Nitro. The natural rubber construction supports a factory-style service replacement for the specified rear suspension position.

Key Features

• Natural rubber construction for suspension service
• Rear upper to axle control arm bushing application
• Inside diameter: 0.49 in
• Outside diameter: 1.85 in
• Length: 2.19 in
• Wall thickness: 0.68 in
• Silver finish
• Mevotech GS25433 part number for identification and ordering

Detailed Description

Mevotech GS25433 is a suspension control arm bushing engineered for the rear upper to axle position. Built from natural rubber, it is sized with a 0.49-inch inside diameter, 1.85-inch outside diameter, 2.19-inch length, and 0.68-inch wall thickness to match the specified suspension location. This bushing is listed for 2005-2007 Jeep Grand Cherokee, 2006-2010 Jeep Commander, 2008-2009 Jeep Liberty, and 2007-2009 Dodge Nitro. The GS25433 part number also cross-references MOOG Chassis Products K200180 for the same application.

For buyers searching for a rear upper axle bushing for Jeep Commander, Jeep Grand Cherokee, or Jeep Liberty, Mevotech GS25433 provides a direct replacement option in the correct suspension position. It is also a fitment match for Dodge Nitro rear upper to axle service.

What It Helps Address

• Excess movement in the rear upper control arm mounting point
• Worn or deteriorated rubber in the axle-side suspension bushing
• Noise from suspension bushing wear at the rear axle location
• Loose-feeling rear suspension geometry caused by bushing wear
• Service replacement needs for Jeep and Dodge rear upper to axle applications

Installation Notes and Tips

Verify the rear upper to axle position before ordering, since this bushing is application-specific. Compare the dimensions and vehicle fitment against the existing part during suspension service. Professional installation is recommended for control arm bushing replacement because removal and pressing procedures may be required.

Quality Assurance

Mevotech GS25433 is a cataloged suspension replacement part with confirmed vehicle fitment for the listed Jeep and Dodge applications. The part number GS25433 is also referenced by Mevotech Original Grade GS25433 and Mevotech Supreme MS25433 for the same application.