Mevotech GS25437 Suspension Control Arm Bushing - Front Lower To Frame

Mevotech GS25437 Suspension Control Arm Bushing

The Mevotech GS25437 is a suspension control arm bushing made from natural rubber for front lower to frame applications. It is built for Chrysler 300, Dodge Challenger, Dodge Charger, and Dodge Magnum models in the confirmed fitment range, with dimensions that match the specified control arm interface.

• Natural rubber construction for suspension isolation and compliance
• Inside diameter: 0.39 in.
• Outside diameter: 2.62 in.
• Length: 2.87 in.
• Wall thickness: 1.11 in.
• Silver finish
• Designed for front lower to frame mounting locations

Fitment Details

Compatible With 2005-2010 Chrysler 300, front lower to frame. Compatible With 2008-2010 Dodge Challenger, front lower to frame. Compatible With 2006-2010 Dodge Charger, front lower to frame. Compatible With 2005-2008 Dodge Magnum, front lower to frame. This part cross-references MOOG Chassis Products K200199 and TRW JBU194 for the same application.

What This Bushing Helps Address

• Excessive play in the front lower control arm mounting point
• Clunking or knocking from worn suspension bushings
• Steering looseness caused by deteriorated rubber isolation
• Uneven tire wear related to suspension movement
• Vibration transfer through the front suspension

Installation Notes and Tips

Verify the vehicle application and mounting position before installation. This bushing is specified for the front lower to frame location, so the existing control arm and bushing dimensions should be checked against the listed measurements before service. Proper suspension inspection and alignment after replacement are recommended to confirm correct geometry on Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum applications.

Quality Assurance

Mevotech GS25437 is an OE-style suspension bushing replacement built to match the listed dimensions and fitment requirements for the confirmed vehicles.