Mevotech GS25484 Suspension Track Bar Bushing - Rear

Rear Track Bar Bushing for Jeep Wrangler

Restore a tighter rear suspension connection with the Mevotech GS25484 suspension track bar bushing. Built from natural rubber with a grey finish, this bushing is sized for the rear track bar location and is engineered for Jeep Wrangler JK and Jeep Wrangler rear applications from 2007-2018.

• Natural rubber construction for suspension isolation and compliance
• Grey finish
• Inside diameter: 0.56 in.
• Outside diameter: 1.57 in.
• Length: 1.595 in.
• Compatible with rear track bar service on Jeep Wrangler JK and Jeep Wrangler

Fitment Details

• Fits 2018 Jeep Wrangler JK, rear
• Fits 2007-2017 Jeep Wrangler, rear

The Mevotech GS25484 is a suspension track bar bushing used in the rear track bar assembly to help maintain proper axle location and suspension geometry. For Jeep Wrangler and Jeep Wrangler JK rear suspension service, this bushing provides the correct dimensions for a direct replacement-style repair. This part cross-references MOOG Chassis Products K200709 for the same application.

Common Repair Symptoms

• Rear axle shift or side-to-side movement
• Clunking or knocking from the rear suspension
• Excessive play in the track bar mounting point
• Worn rubber causing looseness or vibration
• Uneven rear suspension response over bumps

Installation Notes

Verify rear track bar bushing dimensions before installation and inspect the mounting hardware, bracket, and surrounding suspension components for wear. Proper alignment and torque procedures should be followed after service on Jeep Wrangler JK and Jeep Wrangler rear suspension systems. Confirm vehicle year and rear position match the listed fitment before ordering.

Quality Assurance

Mevotech GS25484 is an OE-style suspension service part built to match the listed application dimensions and fitment requirements for rear track bar repair.