Mevotech GS40873 Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Rear Stabilizer Bar Bushing Kit for Ford Fusion and Mercury Milan

Mevotech GS40873 is a suspension stabilizer bar bushing kit built for rear-to-frame applications on select Ford and Mercury sedans. It uses natural rubber construction to help restore a secure sway bar mount and consistent suspension response on the vehicle.

Compatible with 2007-2012 Ford Fusion, rear to frame, and 2007-2009 Mercury Milan, rear to frame, this part is a direct-fit service option for common rear stabilizer bar bushing replacement needs. Mevotech GS40873 also cross-references MOOG Chassis Products K200298 for the same application.

Key Features

• Natural rubber construction for suspension bushing service
• Black finish
• Designed for rear-to-frame stabilizer bar mounting
• Inside diameter: 0.73 in.
• Outside diameter: 1.33 in.
• Length: 1.65 in.; width: 3.35 in.; height: 2.45 in.
• Fits Ford Fusion and Mercury Milan rear stabilizer bar applications

Product Details

Mevotech GS40873 is a rear stabilizer bar bushing kit for vehicles that use a frame-mounted rear sway bar interface. The natural rubber material is selected for a compliant bushing interface that helps maintain stabilizer bar location and reduce unwanted movement at the mounting point. For shoppers searching for a rear sway bar bushing kit for 2007-2012 Ford Fusion or 2007-2009 Mercury Milan, GS40873 provides a fitment-specific replacement option.

This part number, GS40873, is also listed under Mevotech Original Grade and aligns with related aftermarket references for the same rear-to-frame application. If you are replacing worn rear stabilizer bushings on a Ford Fusion or Mercury Milan, this part number is a relevant match to verify against your existing suspension setup.

What It Helps Address

• Clunking or knocking from the rear suspension mount area
• Excess sway bar movement at the frame connection
• Worn, cracked, or flattened stabilizer bar bushings
• Loose-feeling rear suspension response over bumps
• Noise caused by deteriorated rubber at the sway bar bracket

Installation Notes

Confirm rear-to-frame fitment before ordering and compare the existing bushing dimensions to the listed measurements. Mevotech GS40873 is intended for the rear stabilizer bar mounting location on the specified Ford Fusion and Mercury Milan applications. Inspect the stabilizer bar, brackets, and surrounding hardware for wear before installation so the new bushings can seat properly.

Quality Assurance

Mevotech GS40873 is part of Mevotech Original Grade coverage and is cataloged for the confirmed Ford Fusion and Mercury Milan rear-to-frame applications listed above. Verify part number GS40873 against your vehicle details and suspension configuration before installation.