Mevotech GS504350 Suspension Control Arm Bushing - Front Lower Rearward

Mevotech GS504350 Suspension Control Arm Bushing

Mevotech GS504350 is a press-in suspension control arm bushing made from natural rubber with a black finish. It is built for the front lower rearward control arm position on select Cadillac CTS, Cadillac STS, and Cadillac SRX applications, helping restore proper suspension joint support and ride control.

Key Features

• Natural rubber construction for suspension isolation and compliance
• Press-in mounting type for the front lower rearward control arm location
• Black finish with an outside diameter of 2.5 in. and inside diameter of 0.57 in.
• Length measures 2.8 in. for the specified control arm application
• Direct-fit replacement for Cadillac CTS, Cadillac STS, and Cadillac SRX fitments

Detailed Description

The Mevotech GS504350 suspension control arm bushing is engineered for vehicles that use a front lower rearward bushing in the control arm assembly. Its natural rubber material helps maintain suspension articulation while supporting the control arm at the chassis mounting point. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Compatible vehicle coverage includes Fits 2008-2014 Cadillac CTS, Front Lower Rearward; Fits 2005-2011 Cadillac STS, Front Lower Rearward; and Fits 2004-2009 Cadillac SRX, Front Lower Rearward. The GS504350 part number is also referenced as an OE-style replacement under Mevotech Original Grade and cross-references to Mevotech Supreme MS504350.

Common Issues This Part May Address

• Excessive suspension looseness at the control arm mounting point
• Clunking or knocking from worn front lower rearward bushings
• Uneven steering response caused by deteriorated rubber support
• Vibration transfer through the chassis from aged suspension bushings
• Loss of control arm alignment stability under normal driving loads

Installation Notes and Tips

Installation requires press-in service at the front lower rearward control arm position. Inspect the control arm, mounting bore, and surrounding suspension components before installation, and verify the vehicle application by year, make, model, and position before ordering. For best results, replace worn bushings on the affected side or axle as needed and perform a wheel alignment after suspension service.

Quality Assurance

Mevotech Original Grade parts are positioned as OE-style replacement components for specified applications. Confirm fitment against the listed Cadillac CTS, Cadillac STS, and Cadillac SRX year ranges before installation.