Mevotech GS601213 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

OE-Style Front Right Upper Control Arm

Restore steering response and suspension geometry with this Mevotech Original Grade control arm and ball joint assembly. Built for regular commuting and routine driving, it matches original manufacturer fit, form, and function for the 2004-2008 Acura TL front right upper position.

Mevotech GS601213 is a direct-fit suspension control arm and ball joint assembly for the Acura TL, combining a steel arm with a pre-greased ball joint, rubber bushings, and a rubber dust boot. It is engineered as an OE replacement for drivers who want factory-style handling and ride quality without changing the original suspension layout.

• Fits 2004-2008 Acura TL, front right upper
• Mevotech Original Grade premium replacement
• Steel control arm construction with black finish
• Pre-greased ball joint included
• Press-in ball joint with threaded stud type
• Rubber bushings and rubber dust boot included
• Mounting hardware included where required
• Non-adjustable design for OE-style suspension geometry

Detailed Product Overview

This suspension control arm assembly is built to restore the original front suspension position on the Acura TL. The Mevotech GS601213 uses a steel arm for strength, rubber bushings for controlled movement, and a pre-greased ball joint to support smooth articulation. It is a practical OE replacement for maintaining alignment stability, steering feel, and ride consistency on 2004-2008 Acura TL models.

This part cross-references MOOG Chassis Products RK623753 and Delphi TC7268 for the same application. Mevotech GS601213 is also listed among interchange references for the Acura TL front right upper suspension position.

Common Problems This Part Addresses

• Front-end clunking or popping from worn suspension joints
• Loose or inconsistent steering response
• Uneven tire wear caused by suspension wear
• Excessive play in the upper control arm assembly
• Ride quality loss from deteriorated bushings or ball joint components

Installation Notes and Tips

Verify the front right upper position before installation and compare the new assembly to the original part for mounting points and orientation. Because this is a press-in ball joint design, proper service tools and alignment procedures are recommended after installation. Always inspect adjacent suspension components, fasteners, and alignment settings when replacing a control arm on the Acura TL.

Quality Assurance

Mevotech Original Grade parts are built to match original manufacturer fit, form, and function for OE-style replacement service. GS601213 is designed to restore factory-level performance characteristics for everyday driving on the 2004-2008 Acura TL.