Mevotech GS601222 Suspension Trailing Arm - Rear Right Lower Forward

OE-Style Rear Right Lower Forward Trailing Arm

Mevotech GS601222 is a suspension trailing arm built for the rear right lower forward position on select Honda, Acura, and Honda Passport applications. It uses a steel arm with a black finish, rubber bushings, and included mounting hardware to restore proper rear suspension geometry and ride control.

Key Features

• Steel construction for strength and consistent suspension support
• Black coated finish for a clean OE-style appearance
• Rubber bushings included for controlled articulation and road isolation
• Bushing end and fork end configuration for the specified rear suspension location
• Mounting hardware included for a complete replacement installation
• Non-adjustable design for direct replacement use
• Mevotech GS601222 replacement for rear suspension service

Detailed Description

Mevotech GS601222 is a rear suspension trailing arm engineered for the rear right lower forward position. It is a direct-fit OE replacement for the Honda Passport, Honda Ridgeline, Acura MDX, and Honda Pilot applications listed below. The steel arm construction, rubber bushings, and included hardware support proper alignment of the rear suspension linkage while helping restore factory-style handling and ride quality. This part cross-references MOOG Chassis Products RK643428 for the same application.

Compatible With 2019-2025 Honda Passport, rear right lower forward; 2017-2025 Honda Ridgeline, rear right lower forward; 2022-2023 Acura MDX, rear right lower forward; 2014-2020 Acura MDX, rear right lower forward; and 2016-2023 Honda Pilot, rear right lower forward. Mevotech GS601222 is a practical choice when replacing a worn rear trailing arm on these vehicles.

What It Helps Address

• Rear suspension looseness or instability
• Clunking or knocking from worn trailing arm bushings
• Uneven rear wheel tracking caused by suspension wear
• Ride quality changes from deteriorated rear linkage components
• OE-style replacement needs for the rear right lower forward position

Installation Notes and Tips

Verify vehicle year, make, model, and rear right lower forward position before installation. Inspect adjacent bushings, fasteners, and suspension points for wear or damage during replacement. Because this arm is non-adjustable, final suspension geometry should be checked after installation according to service procedures.

Quality Assurance

Mevotech Original Grade parts are built as OE replacement components for common chassis service applications. GS601222 is designed around the listed fitments and uses steel construction with rubber bushings for dependable suspension service.