Mevotech GS76858 Suspension Stabilizer Bar Bushing Kit - Rear To Frame

Mevotech GS76858 Rear Stabilizer Bar Bushing Kit

Restore rear sway bar support on your Mazda 5 with the Mevotech GS76858 stabilizer bar bushing kit. This suspension stabilizer bar bushing kit uses rubber construction and OE-style dimensions to help maintain proper bar location at the rear to frame mounting point.

Built for 2006-2010 Mazda 5 rear to frame applications, the GS76858 is a direct-fit suspension service part for drivers addressing worn stabilizer bushings. This part cross-references MOOG Chassis Products K200623 and Delphi TD1452W for the same application.

Key Features

• Rubber bushing material for suspension mounting support
• Black finish
• Inside diameter: 0.77 in.
• Outside diameter: 1.44 in.
• Length: 1.42 in.; width: 1.41 in.; height: 1.335 in.
• Designed for rear to frame stabilizer bar mounting on Mazda 5
• Mevotech GS76858 part number for catalog matching and service lookup

Detailed Description

The Mevotech GS76858 stabilizer bar bushing kit is made for the rear to frame sway bar location on 2006-2010 Mazda 5 models. As a suspension stabilizer bar bushing kit, it helps secure the stabilizer bar at the frame mount and supports consistent suspension geometry at the rear of the vehicle. The rubber construction and listed dimensions make it a practical OE-style replacement for worn or hardened bushings. If you are searching for a rear sway bar bushing kit for Mazda 5, rear stabilizer bar bushings for 2006-2010 Mazda 5, or Mevotech GS76858 suspension bushing replacement, this part matches that application.

Mevotech GS76858 also cross-references Mevotech Supreme MS76858 and MOOG Chassis Products K200623, giving you a clear part-number reference when comparing catalog listings for the same Mazda 5 rear stabilizer bar service.

Common Problems This Part Addresses

• Clunking or knocking from the rear suspension over bumps
• Excessive play at the stabilizer bar frame mount
• Cracked, flattened, or hardened sway bar bushings
• Loose rear stabilizer bar feel during cornering
• Noise caused by worn rubber suspension bushings

Installation Notes and Tips

Verify the rear to frame mounting location before ordering and compare the existing bushing dimensions to the listed measurements. Clean the stabilizer bar and frame contact surfaces before installation so the new rubber bushing seats properly. For 2006-2010 Mazda 5 rear stabilizer bar service, inspect the bar, brackets, and surrounding suspension components for wear while the area is accessible.

Quality Assurance

Mevotech supplies chassis and suspension components for service replacement applications, and the GS76858 is cataloged with OE-style fitment data for 2006-2010 Mazda 5 rear to frame use. Confirm part number GS76858 against your vehicle application before installation.