Mevotech GS801202 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

The Mevotech GS801202 is a front right lower suspension control arm and ball joint assembly for select Subaru Legacy and Subaru Outback models. Built to match original manufacturer fit, form, and function, it restores OE-style steering response, handling, and ride quality for daily driving.

Compatible with 2015-2019 Subaru Legacy and 2015-2019 Subaru Outback, this assembly is built for the front right lower position and includes the components needed for a direct replacement service.

Key Features

• Exact-match OE replacement design for proper fit and alignment
• Steel control arm construction with black finish
• Pre-greased ball joint for service-ready installation
• Press-in ball joint with threaded stud
• Rubber bushings and rubber dust boot included
• Castle nut, cotter pin, and mounting hardware included where required
• Non-adjustable design for factory-style suspension geometry

Detailed Description

Mevotech Original Grade GS801202 is engineered as a premium replacement for the front right lower control arm on Subaru Legacy and Subaru Outback applications. It is designed to restore original suspension performance by matching OE dimensions and mounting points, while the steel arm, rubber bushings, and pre-greased ball joint support consistent road feel and dependable operation. This part cross-references MOOG Chassis Products RK623476 for the same application.

For shoppers searching for a Subaru Legacy front right lower control arm, Subaru Outback lower control arm assembly, or Mevotech GS801202 replacement, this part provides a direct-fit solution for routine suspension repair.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the lower control arm or ball joint
• Uneven tire wear caused by worn suspension components
• Loose or imprecise steering feel
• Ride quality changes from deteriorated bushings

Installation Notes and Tips

Install GS801202 at the front right lower position only on confirmed Subaru Legacy and Subaru Outback applications. Because this assembly uses a press-in ball joint and threaded stud, verify fastener engagement and suspension alignment after installation. A professional wheel alignment is recommended any time a control arm is replaced.

Quality Assurance

Mevotech Original Grade parts are built as OE-style replacements for regular commuters and routine drivers, with fitment and function aligned to the original suspension design. GS801202 is intended to restore factory-like handling and ride characteristics on the specified Subaru applications.