Mevotech GS861249 Suspension Control Arm and Ball Joint Assembly - Rear Lower

OE-Style Rear Lower Control Arm for Sequoia

Restore rear suspension geometry and ride quality on the Toyota Sequoia with this Mevotech Original Grade control arm and ball joint assembly. Part number GS861249 is built as an exact-match replacement for the original design, with the fit, form, and function needed for everyday driving.

Compatible with 2008-2021 Toyota Sequoia, rear lower, this assembly is built for routine commuters and regular drivers who want OE-style suspension performance. Mevotech GS861249 also includes the ball joint, bushings, dust boot, and required mounting hardware where applicable.

Key Features

• Exact-match OE replacement for the rear lower suspension position
• Pre-greased ball joint for ready-to-install service
• Steel control arm construction with black finish
• Rubber bushings and rubber dust boot for suspension isolation
• Press-in ball joint with threaded stud design
• Castle nut and cotter pin included
• Mevotech Original Grade line focused on restoring OE handling and ride

Detailed Description

The Mevotech GS861249 suspension control arm and ball joint assembly is engineered for the rear lower position on the Toyota Sequoia from 2008 through 2021. It is designed to replace the original component with the same general fit and function, helping return suspension response, alignment stability, and ride comfort to factory-like operation. The steel arm, rubber bushings, and pre-greased ball joint support dependable service in daily use.

This part cross-references Toyota OE-style numbers such as 4873009020 and 4873009030 for the same application. Mevotech GS861249 is a direct-fit solution for Toyota Sequoia rear lower suspension repair when the original arm or ball joint shows wear.

What It Helps Fix

• Rear suspension clunking or looseness
• Uneven tire wear caused by worn control arm bushings or ball joint wear
• Imprecise rear suspension tracking
• Ride quality changes from deteriorated rubber components
• Alignment issues related to worn rear lower suspension parts

Installation Notes and Tips

Verify the rear lower position and confirm vehicle year before installation on your Toyota Sequoia. Because the ball joint uses a press-in mounting type, proper suspension service tools and alignment procedures are recommended after replacement. Inspect adjacent rear suspension components during service to confirm the source of wear.

Quality Assurance

Mevotech Original Grade parts are built as OE-style replacements for fit, form, and function. GS861249 is designed to restore original suspension performance on the Toyota Sequoia with components selected for regular driving conditions.