Mevotech GS861306 Suspension Trailing Arm - Rear Right

Rear Right Suspension Trailing Arm for Toyota Applications

Mevotech GS861306 is a rear right suspension trailing arm built for specific Toyota rear suspension applications. It uses steel construction with a black finish, a rubber bushing at one end, and a bolt-on connection at the other for direct replacement service.

Fits 2019-2025 Toyota RAV4, rear right. Fits 2021-2024 Toyota RAV4 Prime, rear right. Fits 2021-2024 Toyota Venza, rear right.

Key Features

• Steel trailing arm construction for rear suspension service
• Black coated finish
• Rubber bushing included
• Bushing end and bolt-on end configuration
• Non-adjustable design
• Ball joint not included
• Mevotech GS861306 replacement part number

Detailed Description

This Mevotech suspension trailing arm is engineered for the rear right position on select Toyota RAV4, Toyota RAV4 Prime, and Toyota Venza models. The steel arm provides the structural support needed in the rear suspension, while the included rubber bushing helps maintain proper joint isolation at the bushing end. The bolt-on end simplifies replacement of the original trailing arm assembly when servicing worn or damaged rear suspension components. This part cross-references MOOG Chassis Products RK643923 for the same application.

Mevotech GS861306 is a direct-fit suspension component for drivers searching for a rear right Toyota RAV4 trailing arm, a Toyota Venza rear suspension trailing arm, or a Toyota RAV4 Prime rear right suspension replacement. The part number GS861306 is also useful when matching OE-style replacement references during suspension repair.

What This Part Helps Address

• Rear suspension looseness or instability
• Clunking or knocking from the rear suspension area
• Excessive movement caused by worn trailing arm bushings
• Damage to the original rear right trailing arm assembly
• Alignment or handling concerns related to worn suspension linkage

Installation Notes and Tips

Install this trailing arm in the rear right position only on the listed Toyota applications. Verify the vehicle’s suspension layout and compare the original arm length, end style, and mounting points before installation. Because this part is non-adjustable, final suspension geometry should be checked after replacement and any required alignment procedures should be completed according to the vehicle service information.

Quality Assurance

Mevotech supplies chassis and suspension components for OE-style replacement applications. GS861306 is built with steel construction and rubber bushing material to match the demands of rear suspension service on the specified Toyota models.