Mevotech GS90424 Suspension Control Arm Bushing - Front Rearward

Mevotech GS90424 Suspension Control Arm Bushing

Mevotech GS90424 is a press-in suspension control arm bushing made from natural rubber for direct replacement service. It is specified for the front rearward position on 2001-2006 Hyundai Santa Fe models, helping restore proper suspension articulation and control arm isolation.

Key Features

• Natural rubber construction for suspension compliance and vibration isolation
• Press-in mounting type for control arm service
• Inside diameter: 0.48 in.; outside diameter: 2.57 in.; length: 2.46 in.
• Wall thickness: 0.08 in. for OE-style bushing geometry
• Designed for the front rearward control arm location on Hyundai Santa Fe applications
• Mevotech GS90424 cross-references MOOG Chassis Products K200017 and Delphi TD1704W for the same application

Detailed Description

This suspension control arm bushing is built for 2001-2006 Hyundai Santa Fe front rearward service and is sized to match the control arm mounting point. The natural rubber material helps isolate road vibration while maintaining the control arm’s location under load. Mevotech GS90424 is a practical replacement choice when the original bushing is worn, cracked, or no longer holding alignment geometry as intended.

For buyers searching for a Hyundai Santa Fe front rearward control arm bushing, Mevotech GS90424 provides a direct-fit service part with published dimensions for accurate matching. It is also referenced by common aftermarket numbers, including MOOG K200017 and Delphi TD1704W, for the same application.

What It Helps Address

• Clunking or knocking from a worn front suspension bushing
• Excessive control arm movement under braking or cornering
• Rubber cracking, separation, or deterioration at the bushing mount
• Steering feel changes caused by suspension looseness
• Alignment instability related to worn control arm pivot points

Installation Notes and Tips

Mevotech GS90424 uses a press-in design, so the old bushing must be removed and the new bushing installed with proper pressing equipment. Confirm the front rearward position and verify dimensions against the control arm before installation. After service, a wheel alignment is recommended to verify suspension geometry on the 2001-2006 Hyundai Santa Fe.

Quality Assurance

Mevotech manufactures chassis and suspension replacement parts for OE-style service applications. GS90424 is built to published dimensional specifications for the listed Hyundai Santa Fe fitment and is intended for direct replacement use in the front rearward control arm location.