Mevotech H510012 Wheel Bearing - Rear

Mevotech H510012 Wheel Bearing Overview

Mevotech H510012 is a pre-greased Gen 1 wheel bearing for driveline and axle service. It features a 38 mm inside diameter, 70 mm outside diameter, and a non-integral ABS sensor design for applications that use a separate sensor arrangement.

Built for direct wheel-end replacement work, this bearing supports smooth hub rotation and consistent fitment in service applications that call for the H510012 specification. It is a practical choice for technicians servicing wheel bearing noise or wear on select vehicle platforms, including Honda Civic and related applications where this bearing size is specified.

Key Features

• Mevotech part number H510012
• Wheel bearing for driveline and axle repair
• Pre-greased for ready-to-install service preparation
• Gen 1 design type
• Non-integral ABS sensor configuration
• 38 mm inside diameter and 70 mm outside diameter
• 2.77 in. width

Detailed Product Description

The Mevotech H510012 wheel bearing is specified for applications that require a 38 mm inner bore and 70 mm outer diameter, with a 2.77-inch width. Its pre-greased construction helps streamline wheel-end service, while the non-integral ABS sensor setup supports vehicles that use a separate sensor rather than a built-in bearing sensor. If you are sourcing a replacement wheel bearing for Honda Civic service work, H510012 provides the dimensional and design details needed for a proper match.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Part Can Address

• Wheel bearing noise such as humming or growling from the hub area
• Excessive wheel-end play caused by bearing wear
• Rough or inconsistent wheel rotation
• ABS-related service needs where the bearing uses a non-integral sensor design
• Replacement of a worn bearing during driveline and axle maintenance

Installation Notes and Tips

Verify the bearing dimensions, ABS sensor style, and hub design before installation. Match the Mevotech H510012 specification to the vehicle’s original bearing requirements, and inspect the mating surfaces, seals, and hub components for wear or damage during service. Proper press-fit procedures and correct tooling are important for wheel bearing installation.

Quality Assurance

Mevotech is an established aftermarket brand for chassis and driveline components, and H510012 is built to the listed dimensional and design specifications for service replacement use.