Mevotech H510014 Wheel Bearing - Front

Mevotech H510014 Wheel Bearing Overview

Mevotech H510014 is a pre-greased wheel bearing built for driveline and axle service where a compact Gen 1 bearing design is required. It features a 35 mm inside diameter, 64 mm outside diameter, and 2.52 in. width, with a non-integral ABS sensor layout.

For technicians and DIY repairs searching for a Mevotech wheel bearing, H510014 offers a direct-service replacement format for wheel-end maintenance on supported applications. It is also a practical match for wheel bearing replacement searches tied to Honda Civic and similar vehicle fitment needs.

Key Features

• Part number: H510014
• Wheel bearing for driveline and axle applications
• Gen 1 design type
• Pre-greased for service-ready installation
• 35 mm inside diameter
• 64 mm outside diameter
• 2.52 in. width
• Non-integral ABS sensor configuration

Detailed Product Description

Mevotech H510014 is a wheel bearing engineered around a Gen 1 bearing design with a pre-greased construction to simplify wheel-end service. The dimensional specs, including 35 mm inside diameter, 64 mm outside diameter, and 2.52 in. width, make it important to verify the original bearing measurements before installation. This part number is commonly searched as Mevotech H510014 and H510014 wheel bearing for repair work involving Honda Civic wheel bearing replacement and other matched applications.

This part cross-references National 510014 for the same application.

What This Wheel Bearing Helps Address

• Wheel bearing noise such as humming or growling from the hub area
• Excessive wheel play caused by bearing wear
• Rough wheel rotation during inspection
• ABS-related service needs where a non-integral sensor setup is used
• Routine wheel-end maintenance on supported Honda Civic applications

Installation Notes and Tips

Confirm the bearing dimensions, ABS sensor style, and hub configuration against the removed part before installation. Clean the mating surfaces thoroughly, inspect the spindle or hub for scoring, and follow the vehicle service manual for torque and bearing preload procedures where applicable. Because this bearing is pre-greased, do not add grease unless the service procedure specifically calls for it.

Fits 2006-2011 Honda Civic, front.

Quality Assurance

Mevotech supplies replacement chassis and driveline components for service applications, and H510014 is built to match the listed bearing dimensions and configuration details for proper parts matching.