Mevotech H510106 Wheel Bearing - Front

Front Wheel Bearing for Transit Connect

Mevotech H510106 is a pre-greased front wheel bearing for the 2010-2013 Ford Transit Connect. It features a Gen 1 design, a 39 mm inside diameter, a 74 mm outside diameter, and a non-integral ABS sensor setup for direct replacement service.

Key Features

• Fits 2010-2013 Ford Transit Connect, front
• Mevotech H510106 wheel bearing for front hub service
• Pre-greased for installation readiness
• Gen 1 design
• 39 mm inside diameter and 74 mm outside diameter
• Non-integral ABS sensor configuration
• Width: 2.92

Detailed Description

This Mevotech H510106 wheel bearing is built for front axle service on the Ford Transit Connect from 2010 through 2013. The pre-greased construction helps simplify replacement work, while the Gen 1 bearing design and non-integral ABS sensor layout match the listed application requirements. For buyers searching for a front wheel bearing for Ford Transit Connect 2010-2013, H510106 provides the core dimensions and configuration needed for a direct-fit repair.

This part cross-references Timken WB000049 and SKF WKH6520 for the same application.

Common Repair Symptoms

• Front wheel noise that increases with speed
• Rough or loose-feeling wheel rotation
• Vibration from the front hub area
• ABS warning light related to wheel-end sensor configuration
• Excessive play at the front wheel bearing

Installation Notes

Verify the vehicle is a 2010-2013 Ford Transit Connect with front bearing application before ordering. Confirm the inside diameter, outside diameter, and ABS sensor configuration against the removed part. Clean the hub mounting surfaces thoroughly and inspect related components for wear before installing the new Mevotech H510106 bearing.

Quality Assurance

Mevotech supplies chassis and driveline components for replacement service, and this wheel bearing is specified with the dimensions and configuration needed for the listed Transit Connect application. Use the confirmed fitment and part specifications to match the correct front bearing before installation.