Mevotech H512185 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing and Hub Assembly for Mitsubishi Mirage

Mevotech H512185 is a rear wheel bearing and hub assembly built for 1997-1999 Mitsubishi Mirage models. It uses a Gen 3 roll-form design, comes pre-greased, and is built with a non-integral ABS sensor layout for the listed application.

Key Features

• Rear wheel bearing and hub assembly for 1997-1999 Mitsubishi Mirage
• Mevotech Supreme Parts engineering with application-specific design updates
• Gen 3 roll-form design for the hub assembly
• Pre-greased for service-ready installation
• Non-integral ABS sensor configuration
• 4-bolt hole design with 64 mm inside diameter and 125.5 mm outside diameter

Product Details

Mevotech H512185 is a direct-fit rear hub bearing assembly for Mitsubishi Mirage rear applications from 1997 through 1999. The part number H512185 is part of Mevotech Supreme Parts, a line engineered in-house with upgrades aimed at durability and consistent performance in higher-use passenger vehicles, SUVs, fleets, and working trucks. This assembly is built with a Gen 3 roll-form design, pre-greased construction, and a non-integral ABS sensor setup for the specified vehicle fitment.

This part cross-references Centric Parts 405.46010E for the same application.

Common Problems This Part Can Address

• Rear wheel bearing noise or growling from the hub area
• Excessive wheel play or looseness at the rear axle
• Uneven hub rotation caused by worn bearing components
• Service issues on a 1997-1999 Mitsubishi Mirage rear wheel assembly
• Replacement needs for a worn rear hub bearing assembly

Installation Notes and Tips

Confirm rear fitment before ordering: Fits 1997-1999 Mitsubishi Mirage, rear. Verify the ABS sensor configuration, bolt-hole count, and hub dimensions against the original part before installation. The pre-greased design helps streamline service, but proper torque procedures and clean mounting surfaces are still important for a correct repair. The part number H512185 should be matched to the vehicle’s rear hub specification during diagnosis and replacement.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades focused on durability and performance. H512185 is built for the listed Mitsubishi Mirage rear application and follows Mevotech’s Supreme hub bearing assembly design standards.