Mevotech H512277 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub Assembly for Mitsubishi Lancer

Restore smooth rear wheel support with this Mevotech wheel bearing and hub assembly, part number H512277. It is built as a Gen 2 design, pre-greased, and configured with a non-integral ABS sensor for a direct rear service replacement on select Mitsubishi Lancer models.

Compatible with 2002-2006 Mitsubishi Lancer, rear, this hub assembly is a practical choice when you need a replacement for worn bearing noise, looseness, or hub-related vibration. The Mevotech H512277 is also a fitment-based replacement for several cross-reference part numbers used in the same application.

Key Features

• Wheel bearing and hub assembly for rear installation
• Gen 2 design for the specified application
• Pre-greased for ready-to-install service
• Non-integral ABS sensor configuration
• 90 mm inside diameter and 138 mm outside diameter
• 4-bolt-hole mounting pattern
• Mevotech H512277 replacement part number

Detailed Product Overview

The Mevotech H512277 is a rear wheel bearing and hub assembly engineered for 2002-2006 Mitsubishi Lancer applications. Its pre-greased construction helps simplify service, while the Gen 2 hub design supports a straightforward replacement for the original rear hub assembly. The non-integral ABS sensor setup means the vehicle’s ABS arrangement remains separate from the hub unit, matching the listed application requirements. If you are searching for a rear wheel bearing hub assembly for Mitsubishi Lancer 2002-2006, this part number is a direct fitment-based option.

This part cross-references Timken HA590101 for the same application.

Common Problems This Part Can Address

• Rear wheel bearing noise such as humming or growling
• Excessive wheel play from a worn hub assembly
• Vibration or roughness from a deteriorated rear bearing
• ABS-related service needs tied to the rear hub configuration
• Replacement of a damaged or worn Mitsubishi Lancer rear hub

Installation Notes and Tips

Verify rear fitment before installation: this assembly fits 2002-2006 Mitsubishi Lancer, rear. Confirm the 4-bolt-hole pattern, 90 mm inside diameter, and 138 mm outside diameter against the original part before beginning service. Clean the mounting surface thoroughly and inspect surrounding suspension and brake components for wear that could affect final results. Use proper torque procedures during installation and follow the vehicle service manual for rear hub replacement steps.

Quality Assurance

Mevotech supplies replacement driveline and chassis components for service applications, and the H512277 is built to match the listed rear Mitsubishi Lancer fitment. The pre-greased design and application-specific dimensions support consistent service replacement for the confirmed vehicle range.