Mevotech H512329 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing and Hub Assembly for Scion tC and Toyota Celica

Mevotech H512329 is a rear wheel bearing and hub assembly built for select Scion tC and Toyota Celica applications. It combines a pre-greased design with a Gen 3 roll-form construction to support dependable wheel-end service on passenger vehicles, SUVs, fleets, and working trucks.

Mevotech Supreme Parts are engineered in-house with application-specific upgrades focused on durability and service life. The H512329 hub assembly is designed for high-usage rear wheel applications where consistent fit and efficient service matter.

• Rear wheel bearing and hub assembly
• Part number H512329
• Pre-greased for service-ready installation
• Gen 3 roll-form design
• 55 mm inside diameter
• 135 mm outside diameter
• 5 bolt holes with 4 flange bolt holes
• Non-integral ABS sensor design
• Compatible with 2005-2010 Scion tC, rear
• Compatible with 2000-2005 Toyota Celica, rear

Detailed Application and Cross Reference

This rear hub assembly is a direct-fit replacement for vehicles that need a precise wheel-end bearing solution. It cross-references Timken HA590040 for the same application. The H512329 is also referenced in aftermarket catalogs under related numbers such as 295-12329 and 512329E.

For shoppers searching for a rear wheel bearing and hub assembly for 2005-2010 Scion tC or a rear hub assembly for 2000-2005 Toyota Celica, Mevotech H512329 provides the correct fitment profile for those listed applications. It is a practical choice when replacing a worn rear hub on a Scion tC or Toyota Celica.

What This Part Helps Address

• Wheel bearing noise from a worn rear hub assembly
• Excessive wheel play or looseness at the rear axle
• Uneven wheel-end rotation caused by bearing wear
• ABS-related service concerns on non-integral sensor setups
• Restoring proper rear hub support on Scion tC and Toyota Celica models

Installation Notes and Tips

Verify rear position, bolt pattern, and dimensions before installation. Confirm the vehicle uses a non-integral ABS sensor arrangement and compare the existing hub to the listed 55 mm inside diameter, 135 mm outside diameter, and 5-bolt configuration. Clean the mounting surface thoroughly and inspect surrounding suspension and brake components during service.

Quality Assurance

Mevotech Supreme hub bearing assemblies are engineered in-house with application-specific upgrades for durability and performance. The Supreme line is built for demanding passenger and commercial use, with Labor Saver design elements that help streamline installation.