Mevotech H512347HW Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub for Mazda 3 and Mazda 5

Mevotech H512347HW is a rear wheel bearing and hub assembly built for Mazda 3 and Mazda 5 applications that need a direct-fit replacement with application-specific upgrades. It features a Gen 3 roll-form design, is pre-greased, and uses a non-integral ABS sensor layout for the listed rear fitments.

Key Features

• Rear wheel bearing and hub assembly for select Mazda 3, Mazda 3 Sport, and Mazda 5 models
• Gen 3 roll-form design for improved durability in high-use service
• Pre-greased for ready-to-install service preparation
• Non-integral ABS sensor configuration
• 5 bolt holes with 4 flange bolt holes
• Inside diameter: 72 mm
• Outside diameter: 142 mm
• Mevotech Supreme Parts are engineered in-house for commercial, fleet, SUV, and passenger vehicle use

Detailed Description

Mevotech H512347HW is a rear hub bearing assembly engineered for demanding daily driving and higher-mileage service. The Supreme Parts line focuses on application-specific improvements, and this assembly uses a Gen 3 roll-form design to support durability and consistent performance in rear wheel applications. It is pre-greased and built with a non-integral ABS sensor setup for the listed Mazda fitments. This part cross-references Monroe Shocks & Struts (e.g., BBM22615XA) for the same application.

Compatible With 2004-2013 Mazda 3, rear with hardware and upgraded design. Compatible With 2006-2010 Mazda 5, rear with hardware and upgraded design. Compatible With 2010 Mazda 3 Sport, rear with hardware and upgraded design. Compatible With 2012-2015 Mazda 5, rear with hardware and upgraded design. The part number H512347HW is a direct reference for these rear Mazda hub bearing applications.

What It Helps Address

• Rear wheel bearing noise or rough rotation
• Hub play or looseness at the rear wheel
• ABS-related service needs tied to the non-integral sensor design
• Wear from high-usage driving, fleet duty, or daily commuting
• Replacement needs on Mazda 3, Mazda 3 Sport, and Mazda 5 rear hubs

Installation Notes and Tips

Verify rear fitment by year, model, and position before installation. Confirm the 5-bolt hub pattern, 4 flange bolt holes, and 72 mm inside diameter against the original part. Because this assembly is pre-greased, no initial bearing packing is required. Follow factory service procedures for hub removal, torque specifications, and ABS component inspection during replacement. H512347HW is listed for rear applications only.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades for durability and performance in commercial and passenger vehicle service. H512347HW is built as a rear wheel bearing and hub assembly for the listed Mazda applications and is designed around the stated Gen 3 roll-form construction and pre-greased configuration.