Mevotech H512413 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub Assembly for Volvo

Mevotech H512413 is a rear wheel bearing and hub assembly engineered for Volvo applications that need a direct-fit replacement with application-specific upgrades. Built as a Mevotech Supreme Parts component, it is made for higher-use passenger vehicles, SUVs, fleets, and working trucks, with a design focused on durability and easier service.

Key Features

• Rear wheel bearing and hub assembly for select Volvo S60, V60, S80, XC70, and V70 models
• Mevotech Supreme Parts engineering with in-house application-specific design updates
• Gen 3 roll-form design for the hub bearing assembly
• Pre-greased for service-ready installation
• Non-integral ABS sensor configuration
• 5 bolt holes with 4 flange bolt holes
• Inside diameter: 63.5 mm; outside diameter: 136 mm

Detailed Description

The Mevotech H512413 hub assembly is built for rear axle service on select Volvo platforms, including the Volvo S60, Volvo V60, Volvo S80, Volvo XC70, and Volvo V70. It is a pre-greased wheel bearing and hub assembly with a non-integral ABS sensor setup, making it a practical replacement for worn rear hub units where bearing noise, looseness, or wheel-end vibration has developed. This part cross-references SKF BR930563 and Timken HA590460 for the same application. The H512413 is designed to support consistent wheel-end performance in everyday driving and higher-usage conditions.

Vehicle Fitment

• Fits 2012-2018 Volvo S60, rear
• Fits 2015-2018 Volvo V60, rear
• Fits 2007-2016 Volvo S80, rear
• Fits 2011-2016 Volvo XC70, rear
• Fits 2008-2010 Volvo V70, rear

What It Helps Solve

• Rear wheel bearing noise or growling
• Excessive wheel play or looseness at the hub
• ABS-related wheel-end service needs on non-integral sensor setups
• Vibration or roughness from a worn rear hub assembly
• Replacement of a damaged or worn rear bearing unit on Volvo S60, V60, S80, XC70, or V70 models

Installation Notes and Tips

Confirm rear fitment by year, model, and ABS configuration before installation. Inspect the knuckle, axle interface, and mounting surfaces for wear or corrosion, and verify the 5-bolt hub pattern and 4 flange bolt hole layout match the original part. Because the unit is pre-greased, no bearing packing is required before service.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades aimed at improving durability and serviceability. The Labor Saver design approach is used to make installation faster and easier where the application allows.