Mevotech H512452 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub for Mazda CX-9

Mevotech H512452 is a rear wheel bearing and hub assembly for 2007-2015 Mazda CX-9 models. Built for high-use passenger vehicles, SUVs, fleets, and working trucks, it combines application-specific engineering with a Gen 3 roll-form design for dependable wheel-end performance.

Key Features

• Fits 2007-2015 Mazda CX-9, rear
• Wheel bearing and hub assembly for the rear axle
• Gen 3 roll-form design for improved structural consistency
• Pre-greased for service-ready installation
• Non-integral ABS sensor design
• Inside diameter: 72 mm
• Outside diameter: 139.7 mm
• Flange bolt hole quantity: 4
• Number of bolt holes: 5

Detailed Description

Mevotech Supreme H512452 is engineered in-house with application-specific upgrades aimed at durability and consistent operation in demanding daily use. This rear hub bearing assembly is a direct-fit service part for the Mazda CX-9, and its roll-form construction supports the needs of heavier-use vehicles that see frequent road miles and load changes. If you are replacing a worn rear hub on a 2007-2015 Mazda CX-9, H512452 provides the correct fitment and bearing configuration for the rear position.

This part cross-references Timken HA590041 and SKF BR930787 for the same application.

What It Helps Fix

• Rear wheel noise caused by a worn bearing
• Excessive wheel play or looseness at the hub
• Vibration from a deteriorated rear hub assembly
• ABS warning concerns related to hub service on non-integral sensor setups
• Uneven wheel-end operation from age, mileage, or contamination

Installation Notes and Tips

Confirm rear-position fitment before installation on your Mazda CX-9. Verify the 4-bolt flange pattern, 5 bolt holes, 72 mm inside diameter, and 139.7 mm outside diameter against the original part. Because this assembly is pre-greased, it is ready for service, but proper torque procedures and clean mounting surfaces are still important for a correct repair.

Quality Assurance

Mevotech Supreme parts are built with application-specific engineering and labor-saving design features to support faster, more straightforward service. H512452 is manufactured as a wheel bearing and hub assembly for rear use on the Mazda CX-9, with construction details selected for durability in passenger and commercial-duty environments.