Mevotech H512486 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub Assembly for Suzuki SX4

Mevotech H512486 is a rear wheel bearing and hub assembly built for 2008-2013 Suzuki SX4 applications. It combines a pre-greased design with a Gen 3 roll-form construction to support consistent wheel-end performance in high-use passenger and working-vehicle service.

Key Features

• Fits 2008-2013 Suzuki SX4, rear
• Mevotech Supreme Parts engineering with application-specific upgrades
• Pre-greased for ready-to-install service
• Gen 3 roll-form design for hub bearing assembly construction
• Non-integral ABS sensor configuration
• 4 flange bolt holes and 5 bolt holes for the specified application
• Inside diameter: 62 mm; outside diameter: 140 mm

Detailed Description

This Mevotech wheel bearing and hub assembly, part number H512486, is engineered in-house for rear-wheel service on the Suzuki SX4. Mevotech Supreme hub bearing assemblies are built for vehicles that see frequent use, including passenger cars, SUVs, fleets, and working trucks, with design updates focused on durability and service efficiency. For shoppers searching for a rear wheel bearing hub assembly for 2008-2013 Suzuki SX4, H512486 provides the correct fitment and a pre-greased configuration for straightforward replacement.

This part cross-references MOOG Hub Assemblies 512486 for the same application.

Common Problems This Part Can Address

• Wheel bearing noise from the rear hub area
• Excessive wheel play or looseness
• Rough or inconsistent wheel rotation
• Hub wear from high-mileage daily driving
• Replacement needs after bearing or hub assembly failure

Installation Notes and Tips

Confirm rear-position fitment before ordering and verify the bolt pattern, ABS sensor setup, and dimensions against the original part. Because this assembly is pre-greased, it is prepared for installation, but proper torque procedures and clean mounting surfaces are still important for a secure wheel-end repair on the Suzuki SX4.

Quality Assurance

Mevotech Supreme parts are developed with application-specific engineering updates and Labor Saver design elements aimed at making service faster and more efficient. H512486 is built as a direct replacement hub bearing assembly for the listed vehicle application.