Mevotech H516005 Wheel Bearing - Rear

Rear Wheel Bearing for Nissan and INFINITI

Mevotech H516005 is a pre-greased rear wheel bearing built for select Nissan and INFINITI applications. It features a Gen 1 design, a 42 mm inside diameter, an 80 mm outside diameter, and a 3.5 width for a direct-fit service part focused on smooth wheel rotation and dependable hub support.

Key Features

• Pre-greased for ready-to-install service
• Gen 1 wheel bearing design
• 42 mm inside diameter
• 80 mm outside diameter
• 3.5 width
• Non-integral ABS sensor design
• Fits rear position applications

Fitment Details

• Fits 2000-2004 Nissan Frontier, rear
• Fits 1996-2004 Nissan Pathfinder, rear
• Fits 2000-2004 Nissan Xterra, rear
• Fits 1997-2003 INFINITI QX4, rear

Product Overview

This Mevotech wheel bearing, part number H516005, is engineered for rear axle service on the Nissan Frontier, Nissan Pathfinder, Nissan Xterra, and INFINITI QX4. The pre-greased construction helps simplify replacement work, while the non-integral ABS sensor configuration keeps the bearing focused on the mechanical wheel support function. This part cross-references National 516005 for the same application.

Common Repair Uses

• Wheel noise from a worn rear bearing
• Excessive play or looseness at the rear wheel
• Rough rotation during hub inspection
• Service replacement after bearing wear or contamination
• Rear-end vibration traced to bearing condition

Installation Notes

Confirm rear fitment by year, make, and model before installation. Verify the 42 mm inside diameter, 80 mm outside diameter, and 3.5 width against the original bearing specification. Inspect the hub, axle, and surrounding components for wear or damage before pressing in the new bearing. Because this unit uses a non-integral ABS sensor design, compare the vehicle’s sensor arrangement to the original part during service.

Quality Assurance

Mevotech H516005 is built as a service replacement wheel bearing for the listed Nissan and INFINITI rear applications. It is supplied pre-greased and manufactured to match the specified dimensional and design requirements for the confirmed fitment range.