Mevotech HA-38 Wheel Bearing

Mevotech HA-38 Wheel Bearing

The Mevotech HA-38 is a pre-greased wheel bearing for heavy-duty rear axle and front axle applications that require a Gen 1 design with a non-integral ABS sensor. With an inside diameter of 50.8 mm, outside diameter of 82.55 mm, and 2.09 in. width, it is built for specific Ford, Chevrolet, GMC, and Dodge truck and van fitments.

• Pre-greased for direct service installation
• Gen 1 wheel bearing design
• Non-integral ABS sensor configuration
• Inside diameter: 50.8 mm
• Outside diameter: 82.55 mm
• Width: 2.09 in.

Fitment and Cross References

Compatible with applications such as Ford F-250 Super Duty rear outer, Chevrolet Silverado 2500 rear outer, and Dodge W250 rear outer service positions. This part cross-references Timken SET38 and SKF BR38 for the same application.

• Fits 2000-2005 Ford Excursion, rear outer
• Fits 1999-2004 Chevrolet Silverado 2500, rear outer, with 10.5in Ring Gear
• Fits 2001-2004 Chevrolet Silverado 2500 HD, rear outer
• Fits 2001-2004 Chevrolet Suburban 2500, rear outer, with 10.5in Ring Gear
• Fits 2003-2004 Ford E-250, rear outer, with Dana 60 Axle; Full-Floating
• Fits 1999-2004 Ford F-250 Super Duty, rear outer
• Fits 1999-2004 Ford F-350 Super Duty, rear outer, with 10.5in Ring Gear
• Fits 1999-2004 GMC Sierra 2500, rear outer, with 10.5in Ring Gear
• Fits 2001-2004 GMC Sierra 2500 HD, rear outer
• Fits 2003-2004 GMC Yukon XL 2500, rear outer
• Fits 1980-1998 Ford F-250, front outer, with Dana 50.5-BJ Axle
• Fits 1981-1993 Dodge W250, rear outer
• Fits 1981-1993 Dodge W350, front outer

Common Repair Uses

• Rear wheel bearing noise on heavy-duty pickups and vans
• Excessive wheel play or looseness at the hub
• Service replacement for worn rear outer bearing assemblies
• Front outer bearing service on select Ford and Dodge 4x4 applications
• Replacement for pre-greased bearing units during axle maintenance

Installation Notes

Verify axle type, ring gear size, brake configuration, and bearing position before ordering. This HA-38 is used in rear outer, rear inner, front outer, and front inner positions depending on the vehicle, so match the exact application listing to the hub or axle assembly. Confirm the non-integral ABS sensor setup and bearing dimensions during installation.

Quality Assurance

Mevotech supplies this bearing as a pre-greased replacement component for listed truck and van applications. The HA-38 is built to match the specified dimensions and application requirements for direct-fit service on confirmed vehicles.