Mevotech MB10306 Wheel Bearing and Hub Assembly - Front or Rear

Wheel Bearing Hub Assembly for Mini Countryman and Paceman

Mevotech MB10306 is a pre-greased wheel bearing and hub assembly built for front or rear service on select Mini models. It features a Gen 3 roll-form design, a 79 mm inside diameter, a 143 mm outside diameter, and a non-integral ABS sensor layout for direct replacement use.

Key Features

• Wheel bearing and hub assembly for driveline and axle service
• Fits 2011-2016 Mini Cooper Countryman, front and rear
• Fits 2013-2016 Mini Cooper Paceman, front and rear
• Pre-greased for installation-ready bearing service
• Gen 3 roll-form design for hub and bearing support
• Non-integral ABS sensor configuration
• 5 bolt holes with 4 flange bolt holes
• 79 mm inside diameter and 143 mm outside diameter

Detailed Description

Mevotech MB10306 is a wheel bearing and hub assembly engineered for Mini Cooper Countryman and Mini Cooper Paceman applications across the 2011-2016 model years. This assembly is built with a Gen 3 roll-form design and arrives pre-greased, helping simplify replacement of a worn hub unit on the front or rear axle. The non-integral ABS sensor setup supports vehicles that use a separate sensor arrangement, while the 5-bolt hub pattern and 4 flange bolt holes match the specified application requirements. This part cross-references Timken HA590423 and SKF BR930864 for the same application. Mevotech MB10306 is a direct-fit option for drivers searching for a Mini Cooper Countryman wheel bearing hub assembly or a Mini Cooper Paceman hub replacement.

Common Problems This Part Can Address

• Wheel bearing noise such as humming, growling, or rumbling
• Excessive hub play or looseness at the wheel
• ABS warning light concerns related to hub service
• Uneven wheel rotation caused by a worn bearing assembly
• Vibration or instability traced to hub wear

Installation Notes and Tips

Confirm the vehicle position before ordering, since this part is listed for both front and rear applications on the covered Mini models. Verify the hub dimensions, bolt-hole count, and ABS sensor configuration against the original unit before installation. Clean the mounting surface thoroughly and inspect related suspension and brake components while the hub is removed. Professional installation is recommended for proper torque and bearing seating.

Quality Assurance

Mevotech MB10306 is built as a replacement wheel bearing and hub assembly for the specified Mini applications, with pre-greased construction and OE-style dimensional details to support accurate fitment.