Mevotech MB10325 Wheel Bearing and Hub Assembly - Front or Rear

Volvo Hub Bearing Assembly

Mevotech MB10325 is a wheel bearing and hub assembly built for Volvo front and rear applications that demand consistent bearing support and smooth wheel rotation. It is a pre-greased Gen 3 hub assembly engineered for high-usage passenger vehicles, SUVs, fleets, and working trucks.

• Mevotech Supreme Parts engineered in-house for application-specific durability upgrades
• Gen 3 bearing generation for modern hub bearing service requirements
• Pre-greased design for ready-to-install service
• 5 wheel studs and 4 flange bolt holes
• Outside diameter: 136.0 mm
• Inside diameter: 35.6 mm
• Anti-lock brake sensor not included

Fitment Coverage

• Fits 2025 Volvo EC40, rear
• Fits 2025 Volvo EX40, rear
• Fits 2019-2025 Volvo S60, front
• Fits 2017-2025 Volvo S90, front
• Fits 2019-2025 Volvo V60, front
• Fits 2020-2025 Volvo V60 Cross Country, front
• Fits 2017-2025 Volvo V90 Cross Country, front
• Fits 2018-2025 Volvo XC60, front
• Fits 2017-2025 Volvo XC90, front
• Fits 2022-2024 Volvo C40 Recharge, rear
• Fits 2021-2024 Volvo XC40 Recharge, rear
• Fits 2018-2021 Volvo V90, front
• Fits 2016 Volvo XC90, rear

Detailed Description

MB10325 is a direct-fit hub bearing assembly for Volvo models including S60, S90, V60, XC60, and XC90, with coverage for front and rear positions depending on application. Mevotech Supreme hub bearing assemblies are built for commercial and passenger use, and the Labor Saver design focus helps reduce installation time on service jobs where efficiency matters. This part cross-references MOOG Hub Assemblies 512576 for the same application.

Common Service Issues

• Wheel bearing noise or growling from the hub area
• Excessive wheel play or looseness at the hub
• ABS warning concerns when the original sensor is serviced separately
• Uneven wheel rotation caused by worn hub components
• Repeat service on high-mileage Volvo front or rear hub assemblies

Installation Notes

Verify position before ordering, since MB10325 is used on both front and rear Volvo applications. Confirm the 5-stud, 4-bolt flange configuration and match the hub dimensions to the original part. The assembly is pre-greased, and the ABS sensor is not included, so reuse or replace related sensor components as needed based on the vehicle setup.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades aimed at durability and performance in demanding service conditions. MB10325 is built to meet the needs of Volvo drivers and service professionals who need a hub bearing assembly suited to frequent use.